Abstract:Dendrites form on the surface of metal electrodes as a battery undergoes repeated charging and discharging. The formation of dendrites not only affects the electrochemical performances of a battery but may also cause internal short-circuiting and thermal runaway events. Hence, there is a clear need to understand the formation mechanisms and growth kinetics of dendrites. Currently available technologies such as (in-situ) X-ray computed tomography and scanning electron microscopy can be used in a laboratory environment to study dendrite formation. However, they are often prohibitively expensive or unsuitable for long-term, large-scale, and in-operando monitoring. In this study we present an ultrasound-based technique which is cheap, with potential to scale up, and suitable in both laboratory and industrial environments. Different from conventional ultrasonic approaches which excite ultrasonic waves that propagating through layers of cathode, anode and electrolyte, the method presented in this study utilises miniature transducers which excite fundamental shear-horizontal (SH0*) guided ultrasonic waves that propagate along the cathode and anode. Hence, the presented method can individually monitor the condition of multiple electrodes which may be undergoing different ion-insertion mechanisms. A proof-of-concept study was performed on a symmetric aqueous zinc ion cell to explore the sensitivity of SH0* mode guided ultrasonic waves to zinc metal plating/stripping and dendrite formation at the electrode-electrolyte interface. We observed that the attenuation and velocity of waves show cyclical variations when the cell was in a chronopotentiometric cycling test. Variations of wave attenuation and velocity on the opposing working and counter electrode are observed to be in the opposite senses and the increasing/decreasing trends depend on the states (i.e., charging/discharging) of the cell. The cyclical variations of the ultrasound properties are only partially reversible and a monotonic drift can be observed which increases with increasing number of cycles. Coupling the ultrasonic measurements with images acquired by an optical microscope, clear correlations can be observed between changes in ultrasonic wave properties and zinc dendrite thickness. The partially reversible cyclical variations can be attributed to zinc plating/stripping that occur at the electrode-electrolyte interface. The irreversible, monotonic drifting can be attributed to the growth of zinc dendrites on the electrode surface. Hence, these findings demonstrate that the SH0* mode guided ultrasonic waves can offer valuable insights on physical changes at the electrode-electrolyte interface. It is therefore possible to quantitatively model and predict dendrite growth based on ultrasonic measurements. In conclusion, we believe the presented method can inspire more quantitative research on dendrite formation and in-operando monitoring of battery health. Figure 1

The new insight about electrode interface behaviour via in situ ultrasound three-dimensional representation monitoring based on a bio-electrochemical system

The characteristic of electrode of degradation of bio-electrochemical system based on in-situ ultrasonic monitoring: Biofilm and ion precipitation

(Digital Presentation) Monitoring Dendrite Growth in Aqueous Zinc Ion Batteries with Guided Ultrasonic Waves

Bioelectrochemistry for in vivo analysis: Interface engineering toward implantable electrochemical biosensors

Recent Advances in Electrical Transport Spectroscopy for the in Situ Measurement of Electrochemical Interfaces

In situ monitoring of Shewanella oneidensis MR-1 biofilm growth on gold electrodes by using a Pt microelectrode

In Operando Visualization and Dynamic Manipulation of Electrochemical Processes at the Electrode–Solution Interface

Non-destructive characterization of proton diffusion coefficient within live electroactive biofilm

Scanning Acoustic Microscopy for Quantifying Two-phase Transfer in Operando Alkaline Water Electrolyzer

A High-Throughput Electrochemical Impedance Spectroscopy Evaluation of Bioresponsibility of the Titanium Microelectrode Array Integrated with Hydroxyapatite and Silver

Biocompatible Microelectrode for In Vivo Sensing with Improved Performance

Advances in the Application of Quorum Sensing to Regulate Electrode Biofilms in Bioelectrochemical Systems

Single-atom electrocatalysis: a new approach to in vivo electrochemical biosensing

Application of Alternating Current Scanning Electrochemical Microscopy in Lithium‐Ion Batteries: Local Visualization of the Electrode Surface

Progress of electrode/electrolyte interfacial investigation of Li-ion batteries via in situ scanning probe microscopy

Online-monitoring of biofilm formation using nanostructured electrode surfaces

In Situ Monitoring of Wastewater Biofilm Formation Process Via Ultrasonic Time Domain Reflectometry (UTDR)

Monitoring the Behavior of Na Ions and Solid Electrolyte Interphase Formation at an Aluminum/Ionic Liquid Electrode/Electrolyte Interface via Operando Electrochemical X-ray Photoelectron Spectroscopy

Mechanistic Insight into Electrode Processes by Operando Visualization of Interfacial pH Using Fluorescent Nanosensors

Electrically functionalized body surface for deep-tissue bioelectrical recording

An on-chip electrical transport spectroscopy approach for in situ monitoring electrochemical interfaces