Abstract:Solid Phase Extraction Spectroscopy (SPES) developed in this paper is a technique to measure spectrum directly on the solid phase material where the analytes are concentrated in SPE process. Membrane enrichment and UV-Visible spectroscopy were utilized to fulfill SPES, and multivariate calibration method of partial least squares (PLS) was used to simultaneously detect the concentrations of trace cobalt (II) and zinc (II) in water samples. The proposed method is simple, sensitive and selective. The complexes of analyte ions were collected on the cellulose acetate membranes via membrane filtration after the complexation reaction with 1-2-pyridylazo 2-naphthol (PAN). The spectra of the membranes which contained the complexes of metal ions and PAN were measured directly without eluting. The analytical conditions including pH, reaction time, sample volume, the amount of PAN, and flow rates were optimized. Nonionic surfactant Brij-30 was absorbed on the membranes prior to SPES to modify the membranes for improving the enrichment and spectrum measurement. The interference from other ions to the determination was investigated. Under the optimal condition, the absorbance was linearly related to the concentration at the range of 0.1-3.0 μg/L and 0.1-2.0 μg/L, with the correlation coefficients (R(2)) of 0.9977 and 0.9951 for Co (II) and Zn (II), respectively. The limits of detection were 0.066 μg/L for cobalt (II) and 0.104 μg/L for zinc (II). PLS regression with leave-one-out cross-validation was utilized to build models to detect cobalt (II) and zinc (II) in drinking water samples simultaneously. The correlation coefficient between ion concentration and spectrum of calibration set and independent prediction set were 1.0000 and 0.9974 for cobalt (II) and 1.0000 and 0.9956 for zinc (II). For cobalt (II) and zinc (II), the errors of the prediction set were in the range 0.0406-0.1353 μg/L and 0.0025-0.1884 μg/L.

Continuous solid-phase extraction spectroscopy and its quantification method for trace analysis

Automated Online Solid-Phase Extraction Liquid Chromatography Tandem Mass Spectrometry Investigation for Simultaneous Quantification of Per- and Polyfluoroalkyl Substances, Pharmaceuticals and Personal Care Products, and Organophosphorus Flame Retardants in Environmental Waters.

Non-target Screening of Organic Pollutants in Sediments and Sludges Using Gas Chromatography-Mass Spectrometry and Automated Mass Spectral Deconvolution

On-chip Solid Phase Extraction and in Situ Optical Detection.

Quantification of ultra-trace organolead species in environmental water by inductively coupled plasma mass spectrometry with online solid-phase extraction and high performance liquid chromatographic separation

Simultaneous Detection of Trace Metal Ions in Water by Solid Phase Extraction Spectroscopy Combined with Multivariate Calibration.

Solvent-free High-Throughput Analysis of Herbicides in Environmental Water

Investigation on Simultaneous Determination of Deltamethrin, Carbaryl, Microcystin-LR and Benzo[a]pyrene by Online SPE-HPLC Method

Simultaneous Determination of 20 Trace Organic Chemicals in Waters by Solid-Phase Extraction (SPE) with Triple-Quadrupole Mass Spectrometer (Qqq-Ms) and Hybrid Quadrupole Orbitrap High Resolution MS (Q-Orbitrap-hrms)

Covalent Organic Frameworks-Based Solid-Phase Microextraction Probe for Rapid and Ultrasensitive Analysis of Trace Per- and Polyfluoroalkyl Substances Using Mass Spectrometry

Determination of Trace Organic Contaminants by a Novel Mixed-Mode Online Solid-Phase Extraction Coupled to Liquid Chromatography-Tandem Mass Spectrometry

Determination of Nine Emerging Pesticides at Trace Level in Aqueous Samples Using Fully Automated On-Line Solid Phase Extraction Coupled with Liquid Chromatography-Mass Spectrometry

Metal Organic Nanotubes-based Dispersive Solid Phase Extraction-Gas Chromatography-Tandem Mass Spectrometry for SensitiveAnalysis of Polychlorinated Biphenyls in Environmental Water Samples

Rapid and Simultaneous Analysis of Tetrabromobisphenol A and Hexabromocyclododecane in Water by Direct Immersion Solid Phase Microextraction: Uniform Design to Explore Factors.

Coupling Solid-Phase Microextraction with Ambient Mass Spectrometry Using Surface Coated Wooden-Tip Probe for Rapid Analysis of Ultra Trace Perfluorinated Compounds in Complex Samples

Development of an On–site Detection Approach for Rapid and Highly Sensitive Determination of Persistent Organic Pollutants in Real Aquatic Environment

Development of A Magnetic Solid-Phase Extraction Coupled with Gas Chromatography and Mass Spectrometry Method for the Analysis of Semivolatile Organic Compounds

A new on-line SPE LC-HRMS method for simultaneous analysis of selected emerging contaminants in surface waters.

Sorptive Extraction Using Polydimethylsiloxane/Metal-Organic Framework Coated Stir Bars Coupled with High Performance Liquid Chromatography-Fluorescence Detection for the Determination of Polycyclic Aromatic Hydrocarbons in Environmental Water Samples

Quantitative Detection of Zinc Oxide Nanoparticle in Environmental Water by Cloud Point Extraction Combined ICP-MS

Development and Assessment of an Onsite Large Volume Solid Phase Extraction (LV-SPE) Device for the Determination of Pharmaceuticals and Personal Care Products (ppcps) in Water