Preparation of Bi2O3@TiO2 Nanotube Arrays Composite Electrodes and the Detection Performance for 4‐Nitrophenol

Kai Zhao,Xixin Wang,Mengyao Yang,Yuejiao Liu,Jianling Zhao
DOI: https://doi.org/10.1002/slct.202304923
2024-06-20
ChemistrySelect
Abstract:Ti sheet was anodized to get TiO2 nanotube arrays (TNTA). Bi2O3@TNTA composite electrodes fabricated through vacuum impregnation and chemical precipitation method were used as an electrochemical (EC) sensor to detect 4‐NP through cyclic voltammetry measurement. The performance of Bi2O3@TNTA electrode for the detection of 4‐NP is much better than that of TNTA electrode. TiO2 nanotube arrays (TNTA) were prepared by anodization, and then bismuth oxide (Bi2O3) was deposited on TNTA by vacuum impregnation‐chemical precipitation method to prepare Bi2O3@TNTA composite electrodes, which were used to detect 4‐nitrophenol (4‐NP) as an electrochemical (EC) sensor. The effects of the Bi2O3 loading amount and the pH value of the detection solution on the detection performance were exhaustively studied. Under best conditions, the linear range is 5 μΜ–30 mM, the sensitivity is 0.6696 μA ⋅ μM−1 ⋅ cm−2, and the limit of detection is 0.64 μΜ. The composite electrodes are characterized by outstanding reproducibility, superior stability and strong selectivity.
chemistry, multidisciplinary
What problem does this paper attempt to address?