Abstract:This article focuses on the issue of the rotor position estimation error correction for high-speed permanent magnet synchronous motor sensorless drive system. First, a rotor position estimator is designed. Then the estimation error caused by different kinds of nonideal factors is analyzed in detail. Estimation error results in larger amplitude of the stator current, the larger loss, and the degradation of the output torque. To eliminate the estimation error, a novel correction method based on the "minimu-current-tracking (MCT)" method is proposed in this article. The main idea of the proposed method is to obtain the minimum amplitude of the stator current adaptively through the MCT algorithm. The estimation error can be reduced to zero by correcting the compensation factor of the designed position estimator and observing the amplitude of stator current until the amplitude converges to the minimum value. The proposed method has two advantages: 1) the estimation error caused by no matter which kind of nonideal factor can be completely corrected; 2) no sensitive parameters are required in the proposed method. Finally, sufficient simulated results and experimental results verify the effectiveness of the proposed MCT-based method.
automation & control systems,engineering, electrical & electronic,instruments & instrumentation
What problem does this paper attempt to address?
The problem that this paper attempts to solve is the correction of rotor position estimation errors in high - speed permanent magnet synchronous motor (HSPMSM) sensorless drive systems. Specifically, the paper focuses on rotor position estimation errors caused by various non - ideal factors, which will lead to an increase in stator current amplitude, an increase in losses, and a decrease in output torque. To eliminate these estimation errors, the paper proposes a new correction method based on the "Minimum Current Tracking (MCT)" method.
### Core problems of the paper
1. **Rotor position estimation error**:
- In the sensorless drive system of high - speed permanent magnet synchronous motors, due to various non - ideal factors (such as inductance deviation, control delay, iron loss, inverter dead - time, etc.), rotor position estimation errors will occur.
- These errors will affect the performance of the system, such as increasing the stator current amplitude, increasing losses, and reducing the output torque, etc.
2. **Error correction method**:
- The paper proposes a method based on "Minimum Current Tracking (MCT)" to correct rotor position estimation errors.
- This method adaptively obtains the minimum amplitude of the stator current, thereby reducing the estimation error to zero.
### Main contributions
1. **Universality**:
- Regardless of the estimation error caused by which non - ideal factor, it can be completely corrected.
2. **Robustness**:
- This method does not require sensitive parameters, so it has strong robustness to parameter changes.
### Technical details
1. **Rotor position estimator design**:
- A simple rotor position estimator is designed, and the influence of different non - ideal factors on the position estimation error is analyzed.
- The expression of non - quantifiable position estimation error is derived, verifying that these errors cannot be ignored and are difficult to directly compensate.
2. **Principle of MCT method**:
- The position estimation error is corrected by minimizing the amplitude of the stator current.
- Specific steps include: initializing the compensation factor, adjusting the step size according to the rate of change of the stator current amplitude, accumulating the step size to update the compensation factor, and finally making the stator current amplitude converge to the minimum value.
3. **Stability analysis**:
- The stability of the MCT method during the change of stator current is analyzed.
- A method to solve the coupling problem between the current control loop and the tracking loop is proposed, that is, by setting an appropriate control period to eliminate this coupling.
### Conclusion
The rotor position estimation error correction strategy based on the MCT method proposed in the paper can effectively eliminate the estimation errors caused by various non - ideal factors and improve the performance and robustness of the high - speed permanent magnet synchronous motor sensorless drive system.