Abstract:The MAX phase has attracted much attention due to its unique properties combined with the merits of both metal and ceramic, including the low density, high electrical conductivity and good oxidation resistance, which makes it significant for possible applications in various high temperature or other environments. There is a lot of research work on Ti2AlX (X=C, N). However little research about thermodynamic properties at high pressure is carried out. So we study the structural, mechanical and thermodynamic properties of Ti2AlC and Ti2AlN at various pressures and temperatures. The first-principles calculations based on electronic density-functional theory framework are used to investigate the properties at various pressures. The cut-off energy is 350 eV. Converged results are achieved with 10102 special K-point meshes. The self-consistent convergence of total energy is set to be 5.010-6 eV/atom. According to the calculated structural parameters at various pressures, we can find that the ratios V/V0 (V0 denotes the system volume at 0 GPa) of Ti2AlX are reduced by 20.59% and 18.93%, respectively, so the compressibility of the system is strong. As the internal pressure increases, the curves of V/V0 become gentle. Then we calculate elastic constants at pressures ranging from 0 to 50 GPa in steps of 10 GPa. It is obvious that the Ti2AlX is mechanically stable because all of the elastic constants satisfy the Born stability criteria. The bulk modulus, shear modulus and Young's modulus linearly increase with internal pressure increasing, implying that the pressure can improve the resistance to volume deformation. The ductility and brittleness can be judged according to Pugh's criterion (ratio of bulk modulus to shear modulus B/G), and the brittle nature turns into ductile nature in a pressure range of 40-50 GPa for the Ti2AlX since the value of B/G exceeds 1.75. Finally, we study the thermodynamic properties at various pressures and temperatures based on the quasi-harmonic Debye approximation theory, including the bulk modulus, heat capacity and thermal expansion coefficient. The bulk modulus decreases with temperature increasing but increases with pressure increasing. The heat capacity at constant volume Cv and the heat capacity at constant pressure Cp have the same variation tendency, while Cv obeys the Dulong-Petit limit. It is easy to see that temperature and pressure have opposite influences on heat capacity and the effect of temperature is more significant than that of pressure. The effects of temperature and pressure on linear expansion coefficient mainly occur at low temperature and the effect of pressure is not so considerable when the pressure exceeds 30 GPa. Above all, the effects of temperature and pressure on thermodynamic properties are inverse.

Thermodynamic properties and structural phase transition of cerium under high pressure

Phase transition and thermodynamics of thorium from first-principles calculations

Structure phase transformation and equation of state of cerium metal under pressures up to 51 GPa

First-principles study of the high pressure phase transition and lattice dynamics of cerium

Theoretical Investigation of the High Pressure Structure, Lattice Dynamics, Phase Transition, and Thermal Equation of State of Titanium Metal

First-principles Investigation of the Concentration-Dependent Phase Transition of Alloys

Pressure Phase Diagram and Quantum Criticality of Cept2in7 Single Crystals

Ab Initio Study of Magnetic Phase Transition and Electronic Properties of CeFe2 under High Pressure

New Insights into Phase Separation of Cerium Hydrides under Pressure

Elasticity of Cerium Up to 4.4 GPa by Sound Velocity Measurements under Hydrostatic Pressure

Pressure-induced structural phase transition in CeNi: X-ray and neutron scattering studies and first-principles calculations

Superconductivity of Cerium at Quasihydrostatic Pressure Up to 54 GPa

Intermediate-pressure phases of cerium studied by an LDA + Gutzwiller method

Superconductivity of cerium under pressures up to 54GPa

First-principles Investigation of the Structural, Mechanical and Thermodynamic Properties of Al2Cu Phase under Various Pressure and Temperature Conditions

Crystal grain growth during phase transformation in cerium metal at high pressure

First-Order Liquid-Liquid Phase Transition in Cerium

Theory of the crystal structures of cerium and the light actinides

Comment on: "Different Results for the Equilibrium Phases of Cerium above 5 GPa"

Phase diagram of CeVSb3 under pressure and its dependence on pressure conditions

Structural, Mechanical, and Thermodynamic Properties of Ti2AlX (X = C, N) at High Pressure