Abstract:A conjugated alternative copolymer (P0), containing tetraphenylethylene (TPE) and phenylene-ethynylene (PE) units, was prepared by the Sonogashira coupling polymerization with high yield (96.8%). With the aid of activated ester on the PE unit, differently functionalized copolymers (P1 and P2) were derived from P0, and their structures were well characterized using multiple spectroscopic methods. Due to the incorporation of TPE units into the polymer structure, all of these copolymers (P0, P1 and P2) showed aggregation enhanced emission (AEE) properties as revealed by the fluorescence behaviors observed in THF/water and THF/hexane mixtures. As AEE-active polymers, they were investigated for use as fluorescent probes for explosive detection. Using picric acid (PA) as a model explosive, the Stern-Volmer curves showed a super-amplification effect for all these copolymers, and the largest fluorescence quenching constant (k(SV)) was calculated to be 56 100 M-1 for P1 in THF/water mixture with 90% water fraction. This value is comparable to that reported for TPE-containing hyperbranched polymers. By the reaction of the chiral primary amine with P0, the chiral dichroism (CD) signal was recorded for the derived copolymer P1 and the evident Cotton effect shifted to around 380 nm, indicating that the chirality was transferred from the side chain to the main chain. By the substitution of the hydrophobic activated ester with the highly hydrophilic poly(ethylene glycol) (PEG(1000)), the obtained copolymer P2 could be molecularly dispersed in water and gave a clear aqueous solution. The film casting from the P2 THF solution displayed a moderate hydrophilic surface static contact angle of 66.8 degrees, which varied to 33.6 degrees after immersion in THF/water mixture (1 : 1 by volume) for hours, and the microstructural morphology underwent a change from coarse spheres to microfibers, as suggested by scanning electron microscope (SEM) images.

High‐performance tetraphenylethene‐containing poly (p‐phenylene terephthalamide) paper with aggregation‐induced emission characteristics

A phosphorus-, nitrogen- and carbon-containing polyelectrolyte complex: preparation, characterization and its flame retardant performance on polypropylene

Biobased flexible aromatic polyester poly(1,5-pentylene terephthalate) (PPeT): Revisiting melt crystallization behaviors and thermo-mechanical properties

Acid–base-controlled and dibenzylammonium-assisted aggregation induced emission enhancement of poly(tetraphenylethene) with an impressive blue shift

Fully Aminated Rigid‐rod Aromatic Polyamide Efficiently Reinforces Tetraglycidyl Diamino Diphenyl Methane Epoxy Resin and Its Carbon Fiber Composite

Poly(phenylene-ethynylene-alt-tetraphenylethene) copolymers: aggregation enhanced emission, induced circular dichroism, tunable surface wettability and sensitive explosive detection

Effects of Substitution with Donor–Acceptor Groups on the Properties of Tetraphenylethene Trimer: Aggregation-Induced Emission, Solvatochromism, and Mechanochromism

Tetraphenylethenyl-modified perylene bisimide: Aggregation-induced red emission, electrochemical properties and ordered microstructures

Combining aggregation-induced emission and instinct high-performance of polyarylene ether nitriles via end-capping with tetraphenylethene

A new approach to the preparation of poly(p-phenylene terephthalamide) nanofibers

High‐performance composite paper based on heterogeneous polyimide fibers with enhanced mechanical and dielectric properties

Synthesis of Grafted Poly(p‐phenyleneethynylene) with Energy Donor–acceptor Architecture Via Atom Transfer Radical Polymerization: Towards Nonaggregating and Hole‐facilitating Light‐emitting Material

Aggregation-enhanced emission and efficient electroluminescence of conjugated polymers containing tetraphenylethene units

Poly‐(p‐phenylene Vinylenes) with Pendent 2,4‐difluorophenyl and Fluorenyl Moieties: Synthesis, Characterization, and Device Performance

Poly(ester imide)s with Low Linear Coefficients of Thermal Expansion and Low Water Uptake (VIII): Structure-Flame Retardancy Relationship

High Performance All-Para-aramid Paper Prepared by Impregnating Heterocyclic Aramid into Poly(p-Phenylene Terephthalamide) Microfiber/nanofiber-Based Paper

A new class of poly(ether‐ block ‐amide)s based on semi‐aromatic polyamide: synthesis, characterization and structure–property relations

Mechanoresponsive Material of AIE-Active 1,4-Dihydropyrrolo[3,2-b]pyrrole Luminophores Bearing Tetraphenylethylene Group with Rewritable Data Storage

Tetraphenylethylene fused pyrrolo[3,2-b]pyrrole derivatives with reversible mechanofluorochromic and aggregation-induced emission enhancement characteristics

Development of a novel PPTA /cellulose composite insulation paper with low dielectric constant and improved mechanical properties by BTCA crosslinking

Thermoplastic polyimide with good comprehensive performance based on carbazole groups and short flexible linkages