Enhanced cleaner flotation behavior of non-metallic particles in waste printed circuit boards: From the perspective of particle size
Chun-chen Nie,Shun-xiang Shi,Xiang-nan Zhu,Si-qi Jiang,Wen-hao Gao,Hui-li Su,Chuan-ming Li,Xian-jun Lyu
DOI: https://doi.org/10.1016/j.wasman.2022.08.028
IF: 8.816
2022-11-01
Waste Management
Abstract:Flotation is an attractive method for separating the different components of waste printed circuit boards (WPCBs) due to its cleanliness and efficiency. Non-metallic particles (NMPs) with good floatability usually need to be floated, however, it is difficult to achieve complete removal. The effect of particle size on the flotation behavior of NMPs, which is usually ignored in previous studies, is concerned in this paper. Flotation tests and kinetic analysis were carried out to reveal the effect of reagent dosage on flotation characteristics of particles in narrow size fractions. As the fineness decreases, the particles are more likely to be floated. Equally, the finer the particle size, the lower the reagent dosage required to achieve the maximum recovery. For 1–0.5 mm and −0.045 mm, the maximum recovery increased from 42.16% (1500 g/t MIBC) to 97.31% (100 g/t MIBC). Therefore, the feasibility of reducing particle size by grinding to improve floatability was verified. The results show that the reduction of particle size can significantly promote its efficiency of being floated. After grinding treatment, −0.045 mm yields in each size fraction (1–0.5, 0.5–0.25, 0.25–0.125, 0.125–0.074, 0.074–0.045 mm) increased by 22.10%, 28.42%, 30.90%, 64.56%, 89.32%, resulting in an increase of 37.71%, 13.12%, 2.82%, 7.82% and 2.00% in maximum recovery, respectively. It is also proved that the particle size, rather than the resin content, has a more significant effect on the floatability of NMPs.
environmental sciences,engineering, environmental