Abstract:It is well known that free radical (co)-polymerization of multivinyl monomers (MVMs) leads to insoluble gels even at a low monomer conversion, and the gelation point can be predicted by Flory-Stockmayer theory (F-S theory) based on two assumptions: (1) equal reactivity of all vinyl groups and (2) the absence of intramolecular cyclization. This theory has been experimentally studied and o.o verified with conventional free radical (co)polymerization (FRP) of several MVMs (e.g., divinylbenzene, DVB). However, it is still debatable whether this theory is applicable for the polymerization of MVMs using reversible deactivation radical polymerization (RDRP) approaches, such as atom transfer radical polymerization (ATRP). Herein, Monte Carlo simulations using two statistical models-with cyclization (w.c.) and without cyclization (wo.c., corresponding to F-S theory)-and dynamic lattice liquid (DLL) models were conducted to study ATRP of divinyl monomers. The simulated gel points using w.c. and wo.c. models were compared with those obtained from ATRP experiments, from calculation using F-S theory, and from simulations using DLL models. The molecular weights, dispersity, and extent of intermolecular/intramolecular cross-linking were calculated as a function of double bond and cross-linker conversion. The results demonstrated that the gel points obtained from both w.c. and wo.c. models were lower than the values from DLL models and experiments. This indicates that F-S theory cannot be used to accurately predict the polymerization of divinyl monomers via ATRP. Our study shows that the limitation of F-S theory in predicting ATRP reaction of divinyl monomers is not only due to neglecting intramolecular cyclization but also due to spatial restrictions which can cause the reactivity and accessibility of vinyl groups becoming nonequivalent in ATRP of divinyl monomers.

On the Absence of Gel Effect in Radical Ring-Opening Polymerization of Ketene Acetals

Kinetics and Modeling of Solution Arget Atrp of Styrene, Butyl Acrylate, and Methyl Methacrylate

Modeling for the Diffusion Limitation of Free Radical Polymerization

Radical Ring Opening Polymerization of Cyclic Ketene Acetals Derived From d-Glucal

The Effects of Monomer Structure of Cyclic Ketene Acetals on the Behavior of Controlled Radical Ring-Opening Polymerization

The competition between radical copolymerization and charge separation of cyclic ketene acetals and electron‐deficient olefins

Alternating Radical Ring-Opening Polymerization of Cyclic Ketene Acetals: Access to Tunable and Functional Polyester Copolymers

Kinetic Modeling of Surface-Initiated Atom Transfer Radical Polymerization

Quantitative, Regiospecific, and Stereoselective Radical Ring-Opening Polymerization of Monosaccharide Cyclic Ketene Acetals

Active Kinetic Chain Length: Guide for Control in Atom Transfer Radical Polymerization

Kinetic analysis of A 2 + AB 2 polymerization approach

Secondary reactions during acrylate radical polymerization: Determining their rate coefficients

Modelling and Kinetic Study on Radical Polymerization of Methyl Methacrylate in Bulk, 1. Propagation and Termination Rate Coefficients and Initiation Efficiency

Improved Approach for ab Initio Calculations of Rate Coefficients for Secondary Reactions in Acrylate Free-Radical Polymerization

Monte Carlo Simulations Of Atom Transfer Radical (Homo)Polymerization Of Divinyl Monomers: Applicability Of Flory-Stockmayer Theory

Molecular simulation of polymer gels synthesized by free radical copolymerization: Effects of concentrations and reaction rates on structure and mechanical properties

Kinetic Model of Living Radical Polymerization

Non‐steady State Model for Free Radical Polymerization

Towards Predictive Models of Acrylates Free Radical Polymerization in Solution: The Key Role of Solvent-induced Cage Effects

Effect of ketyl radical on the structure and performance of holographic polymer/liquid-crystal composites

Exploring Some Kinetic Aspects of the Free Radical Polymerization of PDMS-MA