Abstract:This work is devoted to evaluating the effectiveness of the recovery of carbon fibers from end−of−life wind turbine blades in the pyrolysis process, and the use of those fibers in the production of flat composite panels. The recovery of carbon fibers from wind turbine blades uses a pyrolysis process at 500–600°C in a non−oxidizing atmosphere, in such a way that makes it possible to preserve the shape and dimensions of the fibers. Using recycled carbon fibers, flat CFRP sheets with epoxy resin matrix were produced by pressing. Seven different series of samples were tested, which differed in fiber length, fiber orientation, and pressure holding time. The results obtained on the recycled fibers were compared to the original carbon fibers, cut to corresponding lengths. Additionally, one of the series was reinforced with a biaxial fabric. The most favorable pressing parameters are empirically found to be pre−pressing 2 MPa (10 min), and further pressing at a pressure of 7 MPa until the resin completely cross−linked (about 120 min). A number of tests were carried out to demonstrate the usefulness of pyrolytic fibers, including tensile strength of carbon fibers, bending strength, SEM observations, FT−IR, and Raman spectroscopy. The tests carried out on the carbon fibers show that the pyrolysis process used leaves about 2% of the matrix on the surface of the fiber, and the tensile strength of the fibers drops by about 20% compared to the new carbon fibers. The research results show that the use of the recycled carbon fibers in the production of flat composite plates is reliable, and their mechanical properties do not differ significantly from plates made of corresponding original carbon fibers. Composite panels with the pyrolytic fibers (274 MPa) show up to a 35% higher flexural strength than similarly produced panels with the original new carbon fibers (203 MPa), which means that the panels can be used in the production of elements for footbridges, bridges, pipelines, or structural elements of buildings and roofing.

Characterization of composite materials with recycled wind turbine blade additives using atomic force microscopy

Recycling of Mechanically Ground Wind Turbine Blades as Filler in Geopolymer Composite

Recycling of waste wind turbine blades for high‐performance polypropylene composites

Recycled wind turbine blades as a feedstock for second generation composites

Recycling of fiberglass wind turbine blades into reinforced filaments for use in Additive Manufacturing

The Use of Carbon Fibers Recovered by Pyrolysis from End-of-Life Wind Turbine Blades in Epoxy-Based Composite Panels

Recycling of both resin and fibre from wind turbine blade waste via small molecule-assisted dissolution

A recyclable epoxy for composite wind turbine blades

Recycling solid residues recovered from glass fibre-reinforced composites – A review applied to wind turbine blade materials

A study on the characteristics and thermal properties of modified regenerated carbon fiber reinforced thermoplastic composite recycled from waste wind turbine blade spar

Study on recycling wind turbine blades into reinforcement for filaments used in 3D printing

Recycled Glass Fiber Composites from Wind Turbine Waste for 3D Printing Feedstock: Effects of Fiber Content and Interface on Mechanical Performance

The Impact of Wood Fibers in Composite Panels Made from Recycled Fiberglass Wind Turbine Blades

Mechanical Properties and Microscopic Study of Recycled Fibre Concrete Based on Wind Turbine Blades

Potential recovery of glass and carbon fibers from wind turbine blades through different valorization techniques

End-of-Life wind turbine blades: Review on recycling strategies

A review on recycling and reuse methods for carbon fiber/glass fiber composites waste from wind turbine blades

Decentralized approach for incorporating waste wind turbine blades into 3D printing filaments using mechanical recycling

Techniques of recycling end-of-life wind turbine blades in the pavement industry: A literature review

Pyrolysis-recycling Utilization Properties Waste Wind Turbine Composite Blades

Possibility of Using Wind Turbine Waste in Particleboard Manufacturing