A DRA With Engraved Groove and Comb-Like Metal Wall for Beamwidth Enhancement in Both E- and H-Planes

Rui-Yang Li,Yong-Chang Jiao,Yi-Xuan Zhang,Li Zhang,Hai-Yan Wang

DOI: https://doi.org/10.1109/lawp.2021.3056541

IF: 4.2

2021-04-01

IEEE Antennas and Wireless Propagation Letters

Abstract:In this letter, a dielectric resonator antenna (DRA) with an engraved groove and a comb-like metal wall for beamwidth enhancement in both E- and H-planes is proposed. First, with an engraved groove, the radiation intensity on the top wall of the rectangular DRA can be enhanced, which significantly broadens the half-power beamwidth (HPBW) in the E-plane. Second, by placing a regular notched metal wall around the grooved DRA, HPBWs in both E- and H-planes can be greatly widened simultaneously. Finally, for the further improvement of HPBW in the H-plane, the regular notched wall is replaced by a 3-D printed comb-like metal wall. Vertical currents can be induced on the comb-like wall due to the coupling of the DRA, which can increase gain at low elevation angles and further enhance HPBW of 20°. Thus, HPBWs of the proposed antenna in both cutting planes can be improved step by step without scarifying each other and bandwidth. To verify the proposed design, an antenna prototype is fabricated and measured, which shows an impedance bandwidth of 38.2% (2.58–3.8 GHz), with excellent HPBW performance of 248° and 148° in the E- and H-planes, respectively.

telecommunications,engineering, electrical & electronic