Investigation of heat generation sources in sonic infrared thermography using laser Doppler vibrometry
F. Freni,R. Montanini,V. Stagno
Abstract:This study aims to investigate the fundamental physics governing the damping-related heat generation and thermal diffusion processes in ultrasound excited infrared thermography. Experimental tests were carried out on a AISI 304 steel beam in which an array of synthetic defects, consisting of 27 flat-bottom holes filled with a viscous material, has been manufactured. The relationship between vibration mode shape, ultrasound excitation frequency and energy dissipation in defective areas is examined by means of concurrent measurements performed by means of sonic activated infrared thermography and scanning laser Doppler vibrometry. Sonic infrared thermography (also called vibrothermography) is a sensitive, very fast, and full-field imaging NDE technique that uses ultrasound-generated heat as defect detection mechanism. The basic principle is based on theory that, as defects may be areas where mechanical damping, plasticity and friction losses primarily take place, the high frequency vibration energy is converted into heat mainly in defects than in sound areas, resulting in a defect selective dark field method [1-3]. The reversible thermoelastic heating and cooling, caused by the induced vibrations in the tens of kilohertz range, are averaged out over the integration time of the IR camera, which is typically around one millisecond. Hence, only irreversible heating is imaged by the IR camera. The heating mechanism in sonic thermography is therefore different from that of stress pattern analysis by thermal emission (SPATE), in which the detection of periodic thermoelastic temperature variations is synchronized with the sinusoidal stress-induced heating and cooling. Basically, two different approaches are used to implement sonic thermography. In the first one, known as ultrasound lock-in thermography (ULT), the high frequency ultrasonic wave used to excite the sample is amplitude modulated at a very low frequency (a few tens of mHz) and the recorded sequence of images is processed in the frequency domain, producing two images: an amplitude image and a phase image. This thermal imaging technique, which has been first developed by the research group of G. Busse in Stuttgart [4-6], has the advantage of being phasesensitive, allowing flaw depth to be retrieved from the phase lag. In addition, it requires only a relatively low excitation power to heat the defect, thus preventing potential damage of the inspected part caused by high-amplitude vibrations. ULT has been proposed in recent years as an effective NDT method in a number of applications, such as imaging of aerospace structures [7], non-destructive testing of adhesive joints and riveted structures [8], maintenance of CFRP rims [9], qualification of industrial cast iron turbocharger components [10] and cracks detection in steel load bearing members [11]. Acoustic excitation can also be accomplished by using short sonic multi-frequency bursts (UBP) [12] or wideband frequency sweeps (UST) [13] in order to reduce the testing time and eliminate the effects related to the onset of undesirable standing wave patterns caused by ultrasound frequency matching with structural resonances. In the second implementation, known as pulsed sonic thermography (PST), a high frequency (typically 20-40 KHz) vibration pulse is applied for a short time (normally less than one second) to produce localized frictional heating at the defect and an infrared camera is used to record the sequence of images of the entire time evolution of the heating process [3]. In this way very quick defect detection can be achieved. For typical complex shaped industrial parts, reflections from various boundaries of the specimen introduce countless conversions among the vibrational modes, leading to a very complicated sound pattern within the part that completely insonifies the regions under inspection during the application of the ultrasonic pulse. However, if a subsurface flaw is present, relative motion between opposing surfaces at the interface will occur, giving rise to concomitant local dissipation of mechanical energy. The flaw thus becomes an internal heating source, which propagates in the material through thermal diffusion and can be revealed by monitoring its effect on the surface temperature distribution.
Physics,Engineering,Materials Science