Mechanical and corrosion performance of Mg alloy via 3DP by full liquid phase sintering

Chen Su,Jingfeng Wang,Junchao Li,Hongyun Li,Ze Zhao

DOI: https://doi.org/10.1016/j.powtec.2022.117138

IF: 5.64

2022-02-01

Powder Technology

Abstract:Three dimensional printing (3DP) additive manufacturing(AM) of magnesium(Mg) alloys is difficult to densify by conventional sintering process which limits its application. In this study, a novel 3DP sintering process with full liquid was utilized to improve performance of Mg alloy. Mg alloy powders were shaped at room temperature with water-based binder, and formed the MgO net-like framework at 90 °C in air atmosphere, then sintered over the liquidus temperature under the Ar atmosphere. The results show that a large amount of liquid alloy can effectively improve the density of the sample by filling the pores and mass transferring, the MgO net-like framework can effectively maintain the original shape of the parts. Density, microstructural, mechanical and corrosion properties of the parts were investigated after sintered at 620 °C for 5, 8, 10 and 12 h. The results indicated an improvement of properties with increasing in sintering time. Swelling phenomenon was not observed in this sintering temperature. The net-like framework structure might prevent the swelling caused by liquid phase flow too. The parts after sintering for 12 h at 620 °C show the remarkable relative density (97.8%), ultimate compressive strength (~354 MPa), and mass loss rate in 25 °C is 139 mm / year.

engineering, chemical