Abstract:Previous studies have demonstrated volatility-dependent absorption of gas-phase volatile organic compounds (VOCs) to Teflon and other polymers. Polymer–VOC interactions are relevant for atmospheric chemistry sampling, as gas–wall partitioning in polymer tubing can cause delays and biases during measurements. They are also relevant to the study of indoor chemistry, where polymer-based materials are abundant (e.g., carpets and paints). In this work, we quantify the absorptive capacities of multiple tubing materials, including four nonconductive polymers (important for gas sampling and indoor air quality), four electrically conductive polymers and two commercial steel coatings (for gas and particle sampling). We compare their performance to previously characterized materials. To quantify the absorptive capacities, we expose the tubing to a series of ketones in the volatility range 10 4 – 10 9 μg m −3 and monitor transmission. For slow-diffusion polymers (e.g., perfluoroalkoxy alkane (PFA) Teflon and nylon), absorption is limited to a thin surface layer, and a single-layer absorption model can fit the data well. For fast-diffusion polymers (e.g., polyethylene and conductive silicone), a larger depth of the polymer is available for diffusion, and a multilayer absorption model is needed. The multilayer model allows fitting solid-phase diffusion coefficients for different materials, which range from 4×10-9 to 4×10-7 cm 2 s −1 . These diffusion coefficients are ∼ 8 orders of magnitude larger than literature values for fluorinated ethylene propylene (FEP) Teflon film. This enormous difference explains the differences in VOC absorption measured here. We fit an equivalent absorptive mass ( C W , μg m −3 ) for each absorptive material. We found PFA to be the least absorptive, with C W ∼ 10 5 μg m −3 , and conductive silicone to be the most absorptive, with C W ∼ 10 13 μg m −3 . PFA transmits VOCs easily and intermediate-volatility species (IVOCs) with quantifiable delays. In contrast, conductive silicone tubing transmits only the most volatile VOCs, denuding all lower-volatility species. Semi-volatile species (SVOCs) are very difficult to sample quantitatively through any tubing material. We demonstrate a system combining several slow- and fast-diffusion tubing materials that can be used to separate a mixture of VOCs into volatility classes. New conductive silicone tubing contaminated the gas stream with siloxanes, but this effect was reduced 10 000-fold for aged tubing, while maintaining the same absorptive properties. SilcoNert (tested in this work) and Silonite (tested in previous work) steel coatings showed gas transmission that was almost as good as PFA, but since they undergo adsorption, their delay times may be humidity- and concentration-dependent.

Solvent Extraction of PDMS Tubing as a New Method for the Capture of Volatile Organic Compounds from Headspace

Absorption of volatile organic compounds (VOCs) by polymer tubing: implications for indoor air and use as a simple gas-phase volatility separation technique

Direct sample introduction GC-MS/MS for quantification of organic chemicals in mammalian tissues and blood extracted with polymers without clean-up

Development of new PDMS in tube extraction microdevice for enhanced monitoring of polycyclic aromatic hydrocarbons and their derivatives in water

Capturing actively produced microbial volatile organic compounds from human associated samples with vacuum assisted sorbent extraction

Absorption and desorption of gaseous toluene by an absorbent microcapsules column.

Solvent-assisted Vacuum Desorption Coupled with Gas Chromatography-Tandem Mass Spectrometry for Rapid Determination of Polycyclic Aromatic Hydrocarbons in Soil Samples.

Design and Application of a Novel Integrated Microsampling System for Simultaneous Collection of Gas- and Particle-Phase Semivolatile Organic Compounds

Sampling of Volatiles in Closed Systems: A Controlled Comparison of Three Solventless Volatile Collection Methods

Systematic study of polymer gas sampling bags for offline analysis of exhaled breath

Cumulative solid phase microextraction sampling for gas chromatography-olfactometry of Shiraz wine

Evaluating polyvinylidene fluoride - carbon black composites as solid phase microextraction coatings for the detection of urinary volatile organic compounds by gas chromatography-mass spectrometry

Quantitative Analysis of Indoor Gaseous Semi-Volatile Organic Compounds Using Solid-Phase Microextraction: Active Sampling and Calibration

Sample preparation for the analysis of volatile organic compounds in air and water matrices

Investigation of operational fundamentals for vacuum-assisted headspace high-capacity solid-phase microextraction and gas chromatographic analysis of semivolatile compounds from a model solid sample

Recovery and reactivity of polycyclic aromatic hydrocarbons collected on selected sorbent tubes and analyzed by thermal desorption-gas chromatography/mass spectrometry

Preparation of a Novel Solid Phase Microextraction Fiber for Headspace GC-MS Analysis of Hazardous Odorants in Landfill Leachate

Use of a superabsorbent polymer for the preconcentration of volatile components from complex matrices

Field demonstration for the solvent-based sampling method to perform compound-specific isotope analysis on gas-phase VOC

Determination of Volatile Water Pollutants Using Cross-Linked Polymeric Ionic Liquid as Solid Phase Micro-Extraction Coatings

A Polythiophene/uio-66 Composite Coating for Extraction of Volatile Organic Compounds Migrated from Ion-Exchange Resins Prior to Their Determination by Gas Chromatography.