Abstract:Aircraft icing is widely recognized as one of the most serious weather hazards to flight safety. Specially designed hydro-/ice-phobic coatings are currently undergoing development for aircraft icing mitigation. It was found that hydro-/icephobic coatings would delay the ice accretion iover airframe surfaces so that the impacted supercooled water droplets could be blown away by the airflow from the airframe surface before being frozen into ice. It is of fundamental importance to understand the wind-driven runback behavior of water droplets over surfaces treated with different coatings, since the corresponding knowledge would be very helpful and essential to develop more efficient anti-/de-icing systems for aircraft icing protection. With the rapid development of surface engineering, a series of specially designed surface coatings succeed in icing mitigation using airflow to remove the remained water. While various hydro-/ice-phobic coatings/surfaces have been developed in recent years, the “state-of-the-art” icephobic coatings/surfaces can be generally divided into three categories, i.e., 1). Lotus-leaf-inspired superhydrophobic surfaces (SHS) with micro-/nano-scale surface textures to achieve very high contact angles (typically > 150°); 2). Pitcherplant-inspired slippery liquid infused porous surfaces (SLIPS) with a layer of liquid lubricant (which is immiscible with water) being sandwiched between ice and solid substrate materials; and 3). Icephobic elastic materials/surfaces with deformable structures/surfaces. SHS has a water droplet contact angle (CA) larger than 150° and a sliding angle (SA) less than 10° . SHS always has a hierarchical structure which is similar to the lotus leaf, and water droplets on SHS appear as water beads which can easily roll off the surface by wind or gravity before frozen. Another strategy to reduce ice adhesion strength to a solid surface is to use a layer of liquid lubricant, which is immiscible with water, between ice and the solid surface. The use of such lubricated surfaces was investigated as early as 1960s, and has gained increasing attentions again recently with the introduction of a concept called Slippery Liquid-Infused Porous Surfaces (SLIPS). SLIPS concept is inspired by the Nepenthes pitcher plants, which have evolved highly slippery, liquidinfused micro-textured rim to capture insects. SLIPS surfaces were not only found to be able to suppress ice/frost accretion by effectively removing condensed moisture even in high humidity conditions, but also exhibit at least an order of magnitude lower ice adhesion than most SHS coatings. More recently, elastic materials/surfaces, such as Polydimethylsiloxane or PDMS in short, which would be structurally deformed/altered dynamically upon applying extra mechanical stress, have also been suggested for icing mitigation. Elastic materials display ultra-low adhesion to ice due to their low work of adhesion and liquidlike deformability, while maintaining good mechanical durability due to their solid-like rigidity. It is found that water droplets would not only be more readily rebounding away from the surface after impingement, but also be able to roll away before frozen due to the hydrophobicity of PDMS. Considering the differences in wettabilities and mechanisms of water repellency, it is necessary to have a systematic understanding of how efficient the surfaces are when the aerodynamic force is applied to remove the adhered water droplets. In the present study, a comprehensive experimental campaign was conducted to characterize the transient runback behaviors of wind-driven water droplets over the surfaces of test plates coated with different hydro-/icephobic coatings (i.e., SHS, SLIPS and PDMS). A high-resolution Particle Image Velocimetry (PIV) system was used to achieve quantitative measurements of the velocity field of the airflow around the wind-driven water droplets on the test surfaces with different wettabilities. With the detailed PIV measurements of the airflow field around the runback water droplets and the droplet profiles, the aerodynamic forces and the adhesion forces acting on the water droplets were estimated. While Fig. 1 shows the experimental setup used in the present study, Fig. 2 to Fig. 3 given some of the typical measurement results. More measurement results and comprehensive analysis and discussions will be provided in the full version of this research paper.

Supercooled Water Droplets Impacting at High Speed on Superhydrophobic Surfaces: Open Questions Related to Icephobicity

Supercooled Water Droplet Impact on Superhydrophobic Surfaces with Various Roughness and Temperature

The coupled impact-freezing mechanism of supercooled droplet on superhydrophobic surface

Freezing-induced wetting transitions on superhydrophobic surfaces

Effect of surface wettability on impact-freezing of supercooled large water droplet

Effect of surface wettability on dynamic behaviors and freezing mechanisms of water droplets impacting cold surfaces

Effect of temperature difference between Impinging Droplet and Cold Superhydrophobic Surface on Its Dynamic Behavior

Imparting icephobicity with substrate flexibility

Effects of surface temperature and Weber number on the dynamic and freezing behavior of impacting water droplets on a superhydrophobic ultra-cold surface

Role of water vapor desublimation in the adhesion of an iced droplet to a superhydrophobic surface

Effects of Surface Roughness on Splashing Characteristics of Large Droplets with Digital Inline Holographic Imaging

Impacting-freezing dynamics of a supercooled water droplet on a cold surface: Rebound and adhesion

Exploiting intermediate wetting on superhydrophobic surfaces for efficient icing prevention

Supercooled water droplet impacting-freezing behaviors on cold superhydrophobic spheres

Bouncing Regimes of Supercooled Water Droplets Impacting Superhydrophobic Surfaces with Controlled Temperature and Humidity

Experimental Investigation on the Wind-driven Runback Motion of Water Droplets over Solid Surfaces with Different Wettabilities

Anti-freezing Characteristics of Water Droplet Impinging the Superhydrophobic Surface: an Experimental and Predictive Study

Spreading and freezing of supercooled water droplets impacting an ice surface

On the role of surface morphology in impacting-freezing dynamics of supercooled droplets

Verification of icephobic/anti-icing properties of a superhydrophobic surface.

3D Simulations of Freezing Characteristics of Double-Droplet Impact on Cold Surfaces with Different Wettability