Abstract:Preheating technology is widely used to improve the emission or efficiency of combustors, such as diesel engines and gasifiers operating at high pressures. Soot is an unwanted by-product, but its formation is unavoidable in high-pressure diffusion combustion. In this study, the effect of preheating temperature on polycyclic aromatic hydrocarbon (PAH) and soot formation in methane/air co-flow flames was comprehensively investigated in the pressure range of 1–5 bar. The temperature of inlet gas ranges from 295 K to 573 K. The soot, PAH, and OH* concentrations were obtained using planar laser-induced incandescence, planar laser induced fluorescence, and chemiluminescence techniques, respectively. The experimental results reveal that soot and PAH formation is greatly enhanced at higher pressure or with a higher preheating temperature of inlet gas. At a fixed preheating temperature, the peak/integrated soot volume fraction follows a power law with pressure. As pressure increases, the enhancement of soot formation by preheating temperature is suppressed. As the preheating temperature is raised from 295 K to 573 K, the integrated soot volume fraction is increased by 33.7 times at 1.5 bar, but the difference narrows to 2.3 times at 5 bar. OH* signal increases with preheating temperature at 1 bar, but the difference becomes indistinguishable at higher pressure. Further, the experimental results were utilized to evaluate the soot modeling, PAH and soot formation under experimental conditions are examined using four different kinetic mechanisms. While the soot trend along different pressure and preheating temperature is qualitatively captured, the quantitative predictions vary depending on the mechanisms. Specifically, KAUST and Narayanaswamy-Blanquart-Pitsch (NBP) mechanisms overpredict the soot volume fraction while DRL and Appel-Bockhorn-Frenklach (ABF) mechanisms underpredicts the soot volume fraction. In terms of the PAH spatial distribution, only DRL and ABF mechanisms show the ability to capture the experimental observations, that is the peak PAH appears in the flame centerline. The reaction pathway analysis indicates both fuel-pyrolysis chemistry and PAH growth chemistry should be accounted for the discrepancy.

The effects of CO 2 /CH 4 ratio on soot formation for autothermal reforming of methane at elevated pressure

The Effects of CO2/CH4 Ratio on Soot Formation for Autothermal Reforming of Methane at Elevated Pressure

Effect of Pressure and CO2 Dilution on Soot Formation in Laminar Inverse Coflow Flame at Conditions Close to Autothermal Reforming

Characterization of CH4-CO2-O2 Diffusion Flames Near Autothermal Reforming Condition

Effect of pressure and CO 2 dilution on soot formation in laminar inverse coflow flame at conditions close to autothermal reforming

Chemical Mechanism of Exhaust Gas Recirculation on Polycyclic Aromatic Hydrocarbons Formation Based on Laser-Induced Fluorescence Measurement

Soot production in high pressure inverse diffusion flames with enriched oxygen in the oxidizer stream

Chemical Suppressive Effect of Ammonia Addition on Soot Formation in Laminar Diffusion Flames

Effect of Dimethyl Ether (DME) Addition on Sooting Limits in Counterflow Diffusion Flames of Ethylene at Elevated Pressures

Experimental and Kinetic Study of the Effects of CO2 and H2O Addition on PAH Formation in Laminar Premixed C2H4/O2/Ar Flames

Experimental and numerical research on the effects of pressure and CO2 dilution on soot formation in laminar co-flow methane/air diffusion flames

The effect of preheating temperature on PAH/soot formation in methane/air co-flow flames at elevated pressure

Oxygen-Free Reforming of Methane into Synthesis Gas in the Presence of H2, H2O, CO, and CO2 Additives Taking into Account the Formation of Soot Particles

Effects of CO 2 Dilution and CH 4 Addition on Laminar Burning Velocities of Syngas at Elevated Pressures: An Experimental and Modeling Study

Effects of CO2 Dilution and CH4 Addition on Laminar Burning Velocities of Syngas at Elevated Pressures: an Experimental and Modeling Study

Relevance of soot formation characteristics to equivalence ratio and CO2 addition of acetylene flame

Effects of N2 and CO2 Addition to Oxidizer on Soot Formation in N-Heptane Laminar Diffusion Flame at Preheating Temperatures

Numerical study on the temperature dependence of soot formation in acetylene pyrolysis blended with methane, formaldehyde, methanol, and dimethyl ether

Evaluation of the Chemical Effect of Carbon Dioxide Dilution to Fuel on Soot Formation in Co-Flow Laminar Ethylene and Propane Diffusion Flames

Effects of simultaneous CO 2 addition to the fuel and oxidizer streams on soot formation in co-flow diffusion ethylene flame

Laminar Flame Speeds of H2/CO with CO2 Dilution at Normal and Elevated Pressures and Temperatures