Abstract:A novel microfluidic picoliter-scale sample introduction approach was developed by combining the spontaneous injection approach with a capillary electrophoresis (CE) system based on a short capillary and slotted-vial array. A droplet splitting phenomenon at the capillary inlet end during the spontaneous sample introduction process was observed for the first time. On the basis of this phenomenon, a translational spontaneous injection approach was established to reduce sample injection volumes to the sub-100 pL range. A versatile high-speed capillary electrophoresis (HSCE) system was built on the basis of this sample injection approach with separation performance comparable to or even better than those reported in microfluidic chip-based CE systems. The HSCE system was composed of a short fused-silica capillary and an automated sample introduction system with slotted sample and buffer reservoirs and a computer-programmed translational stage. The translational spontaneous sample injection was performed by linearly moving the stage, allowing the capillary inlet first to enter the sample solution and then removing it. A droplet was left at the tip end and spontaneously drawn into the capillary by surface tension effect to achieve sample injection. The stage was continuously moved to allow the capillary inlet to be immersed into the buffer solution, and CE separation was performed by applying a high voltage between the buffer and waste reservoirs. With the use of the novel system, high-speed and efficient capillary zone electrophoresis (CZE) separation of a mixture of five fluorescein isothiocyanate (FITC) labeled amino acids was achieved within 5.4 s in a short capillary with a separation length of 15 mm, reaching separation efficiencies up to 0.40 microm plate height. Outstanding peak height precisions ranging from 1.2% to 3.7% RSD were achieved in 51 consecutive separations. By extension of the separation length to 50 mm, both high-speed and high-resolution CZE separation of eight FITC-labeled amino acids could be obtained in less than 21 s with theoretical plates ranging from 163,000 to 251,000 (corresponding to 0.31-0.20 microm plate heights). The present HSCE system also allowed fast chiral separations of FITC-labeled amino acids under micellar electrokinetic chromatography (MEKC) mode within 6.5 s.

Microfluidic Chip-Based Induced Phase Separation Extraction as a Fast and Efficient Miniaturized Sample Preparation Method

Microfluidic Flow-through SPME Chip for Online Separation and MS Detection of Multiple Analyses in Complex Matrix

Preparation of the Capillary-based Microchips for Solid Phase Extraction by Using the Monolithic Frits Prepared by UV-initiated Polymerization

A successive laminar flow extraction for plant medicine preparation by microfluidic chip

On-chip solid phase extraction coupled with electrophoresis using modified magnetic microspheres as stationary phase

Elimination of suction effect in interfacing microchip electrophoresis with inductively coupled plasma mass spectrometry using porous monolithic plugs.

A Microfluidic Chip Based Liquid–liquid Extraction System with Microporous Membrane

Initial Study of Two-Phase Laminar Flow Extraction Chip for Sample Preparation for Gas Chromatography

Nanoliter Scale Parallel Liquid–Liquid Extraction for High‐Throughput Purification on a Droplet Microarray

A microfluidic fluorous solid-phase extraction chip for purification of amino acids.

Fabrication of a polystyrene microfluidic chip coupled to electrospray ionization mass spectrometry for protein analysis.

Extraction of electrokinetically separated analytes with on-demand encapsulation

Microfluidic Picoliter-Scale Translational Spontaneous Sample Introduction for High-Speed Capillary Electrophoresis

Microfluidic Chip-Based Liquid-Liquid Extraction and Preconcentration Using A Subnanoliter-Droplet Trapping Technique

Fabricating And Characterizing The Microfluidic Solid Phase Extraction Module Coupling With Integrated Esi Emitters

In-capillary microextraction for direct mass spectrometry analysis of biological samples.

Integration of laminar flow extraction and capillary electrophoretic separation in one microfluidic chip for detection of plant alkaloids in blood samples

A magnetic solid phase extraction microfluidic chip coupled with gas chromatography-mass spectrometry for the determination of polycyclic aromatic hydrocarbons in aqueous samples

Rapid and Efficient Isotachophoretic Preconcentration in Free Solution Coupled with Gel Electrophoresis Separation on a Microchip Using a Negative Pressure Sampling Technique.

Selectively Modified Microfluidic Chip for Solvent Extraction of Radix Salvia Miltiorrhiza Using Three-Phase Laminar Flow to Provide Double Liquid–liquid Interface Area

Stopped-flow liquid-liquid extraction on microfluidic chips