Melting and Solidification Characteristics of PCM in Oscillated Bundled-Tube Thermal Energy Storage System

Jiangwei Liu,Yuhe Xiao,Dandan Chen,Chong Ye,Changda Nie

DOI: https://doi.org/10.3390/en17081973

IF: 3.2

2024-04-23

Energies

Abstract:Phase change material (PCM) based thermal energy storage (TES) is an important solution to the waste of heat and intermittency of new energy sources. However, the thermal conductivity of most PCMs is low, which severely affects the thermal energy storage performance. Oscillation of the tube bundles in a TES unit can intensify the convection of liquid PCM and, therefore, enhance heat transfer. However, the energy storage performance of bundled-tube TES systems in response to oscillation at different amplitudes and frequencies has not been well understood yet, and the optimum time to apply the oscillation during phase transition remains unexplored. To address this issue, this present study was carried out. First, the melting behaviour of PCM with oscillation starting at different times was investigated. Then, the influences of oscillation frequency and amplitude on the melting performance were explored. Finally, the solidification behaviour of PCM with oscillation starting at different times was examined. Results show that the oscillation can accelerate the phase transition process by enhancing convective heat transfer. Compared to the case without oscillation, the complete melting and solidification times are reduced by 8.2 and 6.7% for the case with oscillation starting at 200 s, respectively. The effect of oscillation frequency on the melting enhancement is negligible, while the oscillation amplitude has an important effect on the melting enhancement.

energy & fuels

What problem does this paper attempt to address?

The problem that this paper attempts to solve is: in the phase - change material (PCM) - based thermal energy storage system, enhance the heat transfer performance through the tube - bundle oscillation, thereby improving the efficiency of thermal energy storage and release. Specifically, the author focuses on the influence of oscillation on the melting and solidification characteristics of PCM, especially the performance under different amplitudes, frequencies and oscillation start times.

### Problem Background

The phase - change material (PCM) - based thermal energy storage (TES) technology is an important solution to deal with the intermittency and randomness of new energy. However, most PCMs have a low thermal conductivity, which seriously affects the thermal energy storage performance. The oscillating tube bundle can strengthen the convection of liquid PCM, thereby enhancing the heat transfer effect. However, the influence of oscillation on the performance of the tube - bundle - type thermal energy storage system under different amplitudes and frequencies has not been fully understood, and the optimal start - up time of oscillation during the phase - change process has not been explored either.

### Research Purposes

To solve the above problems, this paper conducts the following research:
1. **Melting Behavior**: The melting behavior of PCM when oscillation starts at different times is studied.
2. **Influence of Oscillation Frequency and Amplitude**: The influence of oscillation frequency and amplitude on the melting performance is explored.
3. **Solidification Behavior**: The solidification behavior of PCM when oscillation starts at different times is investigated.

### Main Findings

The research shows that oscillation can accelerate the phase - change process by enhancing convective heat transfer. Compared with the non - oscillating situation, when the oscillation starts at 200 seconds, the time for complete melting and solidification is reduced by 8.2% and 6.7% respectively. The oscillation frequency has a relatively small influence on the melting enhancement effect, while the oscillation amplitude has a significant influence on the melting enhancement.

### Formula Representation

The oscillation velocity formula is:
\[ v = A\times\sin(2\pi w\times t) \]
where \( A \) is the oscillation amplitude and \( w \) is the oscillation frequency.

These research results are helpful for optimizing the performance of the tube - bundle - type thermal energy storage system, especially in the application in new energy utilization.