Dynamics of Mars and Origin of Tharsis
Lianxing Wen
2009-01-01
Abstract:Introduction: Whether the topography of Mars is supported by loading of an elastic shell at the surface or by viscous flow in the interior has been controversial [1-9]. On Mars, in particular, because a significant portion of the gravity and topography signals is manifested in the Tharsis province, distinguishing these two mechanisms is also crucial to deciphering origin and formation of Tharsis. Here, I address these issues by separating various components of the topography related to different geological events and studying them through jointly modeling the observed geoid at wavelengths of spherical harmonic degrees l = 2 – 12, on the basis of elastic loading and viscous flow. Approach: I construct “residual topography” by excluding the components related to the south-north dichotomy and the major impact basins from the global solutions. I also isolate the topography in the major volcano regions, which I define as “volcano topography”. The major volcano regions include the Tharsis province, Elysium and Olympus. I define “dynamic topography” as the topographic contributions related to the deep mantle buoyancy. If there is no dynamic topography on Mars, the volcano topography should be the manifestation of volcano loading on the outer elastic shell. In this scenario, the residual topography should match the volcano topography plus the flexure effects due to the elastic loading, and the predicted geoid should match the observations, in both amplitude and pattern, at all wavelengths. However, if there is dynamic topography present, the residual topography would represent a combination of the topography related to the volcano load, the flexure effects of the volcano load and dynamic topography. The volcano topography, as defined, is a combination of the topography related to the volcano load (note: different from the volcano topography as defined) and the component due to localization of dynamic topography in the volcano regions. In this scenario, the predicted geoid based on the volcano topography would also be different from the observations. Because the volcano regions can be easily identified and isolated, the above relationships between residual topography, volcano topography and geoid provide a straightforward way to test the volcano loading on an elastic plate and to identify any components of dynamic topography related to deep mantle buoyancy. Results: At the intermediate wavelengths of degrees l = 4 – 12, the observed topography of the major volcanoes on Mars, Tharsis, Elysium and Olympus, can account for the residual topography and explain the observed geoid by loading response of a 100-km thick surface elastic layer (Figure 1).