Abstract:In this study, we successfully synthesized a TiO2/CuO nanocomposite using the aqueous extract of Impatiens tinctoria A.rich. leaf extract as a capping, reducing, and stabilizing agent for the first time in an environmentally friendly, low-cost, straightforward, and sustainable technique. Numerous characterization techniques such as ultraviolet-visible diffuse reflectance spectroscopy (UV-vis-DRS), photoluminescence (PL), Raman spectroscopy, Fourier-transform infrared (FTIR), energy dispersive X-ray (EDX), transmission electron microscopy (TEM), X-ray diffraction (XRD), scanning electron microscopy (SEM), Brunauer-Emmett-Teller (BET), and high resolution TEM (HRTEM) were used to characterize the obtained TiO2/CuO nanocomposite. XRD verified that the TiO2/CuO nanocomposite has an average crystallite size of about 21 nm. The TEM result revealed an average particle size of 29 nm for the biosynthesized TiO2/CuO NC. The HRTEM analysis showed the presence of polycrystalline structures with the predominant lattice fringes 0.352 and 0.19 which were attributed to anatase phase TiO2 in the crystal plane of (101) and (200), respectively. The lattice fringes for monoclinic CuO were observed with values of 0.213 and 0.252 for the lattice planes of (111) and (111̅), respectively. The photoluminescence spectroscopic analysis revealed that the TiO2/CuO NC showed the lowest intensity compared to the pristine TiO2 and CuO indicating the reduction of exciton recombination in the case of the TiO2/CuO NC. The BET analysis showcased the formation of mesoporous materials with a surface area of 87.5 m2/g. The photocatalytic degradation performance of the biosynthesized TiO2, CuO, and TiO2/CuO nanomaterials against the potentially harmful MB dye was tested using the light source of a 150 tungsten-halogen lamp with a wavelength range of 360-2800 nm. The factors affecting photodegradation efficiencies like catalyst dose (20 mg), dye concentration(15 ppm), pH (9), and reaction time (90 min) were optimized for the degradation of the MB dye. The TiO2/CuO catalyst showed the highest degradation efficiency of 99% under the optimized conditions. The degradation rate of the MB dye in the presence of the TiO2/CuO NC was evaluated and found to be fitted to the pseudo-first-order kinetics with a rate constant of 0.03 min-1. The reusability test of the TiO2/CuO catalyst showed its good stability.

Electrochemical fabrication of TiO2/TiP2O7 and Ag/TiO2/TiP2O7 nanocomposites for heavy metal detection and methylene blue dye degradation

Highly-enhanced Performance of TiO 2 Nanotubes Attached with CdS quantum Dots

Fabrication of Fe<SUB>2</SUB>O<SUB>3</SUB>/TiO<SUB>2</SUB> Nanotube Electrode and Its Photoelectrocatalytic Performance in Dye Wastewater Degradation

Fabrication of Fe2O3/TiO2 Nanotube Electrode and Its Photoelectrocatalytic Performance in Dye Wastewater Degradation

Fabrication of Fe 2 O 3 /TiO 2 Nanotube Electrode and Its Photoelectrocatalytic Performance in Dye Wastewater Degradation: Fabrication of Fe 2 O 3 /TiO 2 Nanotube Electrode and Its Photoelectrocatalytic Performance in Dye Wastewater Degradation

Synthesis of Co3O4/Ag/TiO2 Nanotubes Arrays Via Photo-Deposition of Ag and Modification of Co3O4 (311) for Enhancement of Visible-Light Photoelectrochemical Performance

Fabrication and characterization of Th(MoO4)2/TiO2 nanocomposite for potential use in photocatalytic degradation of toxic pollutants

Photoelectrochemical Activity of CdS/Ag/TiO2 Nanorod Composites: Degradation of Nitrobenzene Coupled with the Concomitant Production of Molecular Hydrogen

Synthesize of heterostructure TiO2 by simultaneous doping of double silver and phosphate to degradation of methylene blue under visible light

Hydrothermal synthesis of novel heterostructured Ag/TiO2 /CuFe2 O4 nanocomposite: Characterization, enhanced photocatalytic degradation of methylene blue dye, and efficient antibacterial studies

Enhanced Visible-Light Photocatalysis Activity of TiO2/Ag Nanocomposites Prepared by the Ultrasound-Assisted Sol–Gel Method: Characterization and Degradation–Mineralization of Cationic and Anionic Dyes

Fe2 O3 -Tio2 Nanocomposites for Enhanced Charge Separation and Photocatalytic Activity.

Fabrication of SnO2/TiO2 composite by a chemical co-precipitation method for efficient electrocatalytic oxidation of methylene blue

Fabrication of MnO2/TiO2 nano-tube arrays photoelectrode and its enhanced visible light photoelectrocatalytic performance and mechanism

Hydrothermally Synthesized TiO2-Doped MnO2 Nanocomposites for Electrochemical and Photocatalytic Activity

Photocatalytic Degradation of Dyes Using Titania Nanoparticles Supported in Metal-Organic Materials Based on Iron

Large Scale Photochemical Synthesis of M@TiO2 Nanocomposites (M = Ag, Pd, Au, Pt) and Their Optical Properties, CO Oxidation Performance, and Antibacterial Effect

Plasmon Enhanced Photocatalytic and Antimicrobial Activities of Ag-TiO2 Nanocomposites under Visible Light Irradiation Prepared by DBD Cold Plasma Treatment.

Biosynthesis of TiO2/CuO and Its Application for the Photocatalytic Removal of the Methylene Blue Dye

TiO2-x/Ag/rGO composites as effective photocatalysts for degradation of organic pollutants

Nanosize and Bimodal Porous Polyoxotungstate–anatase TiO2 Composites: Preparation and Photocatalytic Degradation of Organophosphorus Pesticide Using Visible-Light Excitation