Rapid Detection Of Lead Ion (Ii) Based On Cationic Conjugated Polymer And Aptamer
Liu Xing-Fen,Wang Ya-Teng,Hua Xiao-Xiao,Huang Yan-Qin,Feng Xiao-Miao,Fan Qu-Li,Huang Wei
DOI: https://doi.org/10.11895/j.issn.0253.3820.160010
IF: 1.193
2016-01-01
Chinese Journal of Analytical Chemistry
Abstract:A sensitive method for Pb2+ detection based on a cationic conjugated polymer and aptamer was established. By selecting a more specific aptamer probe, the interference of Pb2+ detection from Hg2+ was eliminated remarkably. The probe for Pb2+ recognition and combination is a single stranded oligonucleotide labeled with fluorescein (TBAA, 5'-6-FAM-GGAAGGTGTGGAAGG-3'). When combining with Pb2+ with high specificity, the random coiled probe changed to a G. quadruplex with higher charge density, which enhanced the electrostatic interactions between the oligonucleotide and cationic conjugated polymer, thus the two fluorophores were in more close proximity, leading to a significantly increased fluorescence resonance energy transfer (FRET) signal. However, other non. target metal ions produced much lower FRET signals because they could not combine with the probe and thus quenched the fluorescence of the conjugated polymer and fluorescein. This method was rapid, highly specific and sensitive, and the common metal ions including Li+, Na+, K+, Ca2+, Mg2+, Ba2+, Fe2+, Co2+, Ni2+, Cu2+, Zn2+, Cd2+ and Hg2+ exhibited no influence on the detection of Pb2+. The limit of detection for Pb2+ in lake water was estimated to be 1 nmol/L (3 sigma), which was far below the maximum permitted level of Pb2+ in drink water regulated by the national standard for drinking water quality. Therefore, this FRET. based method provides a new simple, rapid, and efficient method for detection of Pb2+ in various source of water.