Production and purification of organic acids from partially oxidised waste activated sludge

Daniel Núñez,Martina Zabatta,Paula Oulego,Sergio Collado,Francisco A. Riera,Mario Díaz
DOI: https://doi.org/10.1016/j.seppur.2024.126815
IF: 8.6
2024-03-22
Separation and Purification Technology
Abstract:Short-chain organic acids (SCFAs) are widely used in the chemical and food industries. However, their conventional production relies heavily on fossil raw materials, necessitating sustainable alternatives. Waste activated sludge (WAS) can serve as a renewable feedstock for SCFA production through oxidative hydrothermal pretreatment. Thus, the aim of this work was to optimize the production and recovery of SCFAs from partially oxidised WAS. To achieve this, WAS was treated by wet oxidation (WO) at different temperatures (160–200 °C) and ultrafiltered using ceramic membranes (50 and 1 kDa) to pre-purify the SCFAs. Subsequently, these acids were extracted with different combinations of trioctylamine (TOA), tributylphosphate (TBP) and octan-1-ol in the temperature range 25–50 °C. WO at 160 °C for 240 min maximized the SCFA production, obtaining a concentration of 6.07 g/L, with acetic acid as the main component (28.2 %). Membrane ultrafiltration operating in total recycle mode achieved rejections of 39% for TOC and 73% for colour, with a low SCFA rejection (4%) effectively pre-purifying the SCFAs present in the WAS. The main fouling mechanism was cake formation. The highest extraction yields of SCFAs at room temperature were achieved with a mixture of TOA and TBP at 10 % in octan-1-ol, extracting 34 % of the total SCFAs present in the 1 kDa permeate. Lower extraction yields were obtained with the pre-purified WAS compared to synthetic solutions of SCFAs, showing the detrimental effect of the matrix in liquid–liquid extraction. Increasing the temperature within the range of 25–50 °C generally had a favourable effect on the SCFA extraction.
engineering, chemical
What problem does this paper attempt to address?