Facile fabrication of Ag decorated MnFeO 3 catalyst: Comparative analysis of visible light driven antibiotic reduction and antibacterial performance

Şeyda Karadirek,Özlem Tuna,Esra Bilgin Simsek,Seda Altuntas,Aycan Yigit Cinar

DOI: https://doi.org/10.1016/j.jenvman.2024.120891

IF: 8.7

2024-04-24

Journal of Environmental Management

Abstract:Photocatalysis is an effective method with the potential to eliminate pharmaceutical compounds from water sources. Manganese ferrite (MnFeO 3 ), a type of multiferroic perovskite catalyst, has attracted significant attention due to its small band gap, however its application was limited due to its high recombination rate and low quantum efficiency. It was therefore aimed to improve the properties of MnFeO 3 by doping silver (Ag)-particles. In this study, Ag–MnFeO 3 photocatalysts with different Ag content (1–3 mmol%) were synthesized by performing a facile hydrothermal method. The as-prepared samples were characterized using x-ray diffraction (XRD), scanning electron microscopy with energy-dispersive X-ray spectroscopy (SEM/EDS), transmission electron microscopy (TEM), x-ray photoelectron spectroscopy (XPS), ultraviolet–visible spectroscopy (DRS), photoluminescence spectroscopy (PL), electrochemical impedance spectroscopy (EIS) and Brunauer-Emmett-Teller (BET) method, showing successful addition of Ag-particles with the MnFeO 3 structure. Then, the as-synthesized materials were investigated as: (i) photocatalysts for degradation tetracycline (TC) antibiotic and (ii) antibacterial agents for bacteria. The Ag–MnFeO 3 catalyst demonstrated superior catalytic performance (95.7%), which was 1.6 times higher than that of pristine MnFeO 3 (59.7%). The positive effect was ascribed to oxygen vacancies, enhanced light absorption ability, and lower recombination rate. The Ag–MnFeO 3 catalyst also showed satisfactory removal performances in real water matrices. Furthermore, radical trapping tests depicted that the superoxide radicals played a dominant role in the photodegradation system. In addition, Box–Behnken design (BBD) was performed to determine the optimum conditions, which were determined as catalyst dosage of 0.45 g/L, initial TC concentration of 5.10 mg/L, and initial solution pH value of 3.69. In terms of antibacterial tests, the incorporation of Ag into the MnFeO 3 structure greatly increased the antimicrobial resistance against bacteria. Our findings disclose that the incorporation of Ag into the MnFeO 3 structure can be regarded as a feasible and promising approach to improve both photocatalytic degradation and antibacterial performances.

environmental sciences