Effect of transition metals on the interfacial reactions in electroless Ni(P)-solder interconnections

Yao-Ren Liu,Jenn-Ming Song,Y. Lai,Y. Chiu,Wei-ting Chen
DOI: https://doi.org/10.1109/EMAP.2008.4784282
2008-10-01
Abstract:The effect of transition metal (TM) additive of Ni, Co or Zn on the interfacial reactions of the solder joints between Sn-Ag-Cu (SAC) solder and the Cu/Ni(P)/Au substrate was investigated, especially when subsequent to multi-reflowing. (Cu,Ni)6Sn5 formed at the interface of all the joints but the SAC-Ni of which the interfacial compound was (Ni,Cu)6Sn5. The interfacial compounds of the SAC-Co and SAC-Zn contained a small amount of alloying elements of less than 3at%. Two P-rich layers, Ni3P and Ni-Sn-P were found have emerged at the interface of the SAC joints. Nanoindentation analysis indicates that the hardness and Young's modulus of these two phases were slightly higher than Ni(P) substrate, which were in turn much greater than Cu-Ni-Sn compounds. Worthy of notice is that with TM additions the Ni-Sn-P phase between Ni3P and interfacial compounds was absent even after 10-time reflows. For the SAC-Co joints, the growth of Ni-containing intermetallic compounds (IMCs) within the solder gave rise to the excess Ni dissolution which caused a discrete Ni3P layer and over-consumed Ni(P) substrate underneath the grooves in-between (Cu, Ni)6Sn5 scallop grains at the interface.
What problem does this paper attempt to address?