Abstract:To address the effect of parameter variation on the dead-beat predictive current control, this paper proposes a composite dead-beat predictive current control strategy. Firstly, the traditional dead-beat predictive current control and the traditional longberg observer are introduced. Subsequently, the effect of motor nominal value mismatch on the predictive current control and longberg observer gain is analyzed, the results show that the motor parameter error affects the current in the d-q axis, and the excessive flux linkage error causes large current fluctuations. To simplify the complexity of calculating the gain of the full-order longberg observer, the reduced-order longberg observer is designed, and the computation of the gain is largely simplified. Meanwhile, to eliminate the effect of flux linkage on the q-axis current, a reduced-order incremental longberg observer is designed, and the effect of the flux linkage variation on the q-axis current is effectively solved. To address the effect of the nominal value error, the parameter identification is introduced and the composite dead-beat predictive current control strategy is proposed. The nominal value of the motor is identified by the recursive least squares identification, then input into the controller to correct the parameters of the controller. Finally, the simulation validation in Matlab / Simulink is performed, and the results show that the composite dead-beat predictive current control has a faster current response speed and smaller current fluctuation, and the effect of flux linkage variation on the motor system is eliminated.

Model-free deadbeat predictive current control of NIPMVMs considering dead-time effect

Robustness Analysis and Enhancement of Deadbeat Predictive Control for Permanent Magnet Linear Synchronous Machines with Asymmetric Model

A Fast Response Robust Deadbeat Predictive Current Control for Permanent Magnet Synchronous Motor

A Robust Deadbeat Predictive Current Control Method for IPMSM

A Modified Deadbeat Predictive Current Control for Improving Dynamic Performance of PMSM

A Modified Deadbeat Predictive Current Control with Improved Dynamic Performance under Insufficient Voltage Margin for IPMSM

Improved Model-Free Deadbeat Predictive Current Controller for PMSMs Based on Ultralocal Model and H∞ Norm

An Incremental Deadbeat Predictive Current Control Method for PMSM with Low Sensitivity to Parameter Variation

A New Sliding-Mode Observer-Based Deadbeat Predictive Current Control Method for Permanent Magnet Motor Drive

Improved Model Predictive Current Control for PMSM Drives Based on Dynamic Reference Current

Current Prediction Error Reduction Method of Predictive Current Control for Permanent Magnet Synchronous Motors.

Model Predictive Current Control with Adaptive-Adjusting Timescales for PMSMs

An Improved Deadbeat Predictive Current Control Strategy for Interior Permanent Magnet Synchronous Motors

Improved Deadbeat Predictive Current Control with Extended State Observer for Dual Three-Phase PMSMs

Improved Deadbeat Predictive Current Control to Enhance the Performance of the Drive System of Permanent Magnet Synchronous Motors

Improved Deadbeat Predictive Current Control of PMSM Based on a Resistance Adaptive Position Observer

A Deadbeat Predictive Current Harmonics Suppression Method for IPMSM Based on Quasi Proportional Resonant Control

Composite Dead-beat Predictive Current Control of PMSM

Novel Deadbeat Predictive Current Control for PMSM With Parameter Updating Scheme

Deadbeat Predictive Current Control Based on Accurate Discrete Luenberger Observer for PMSM under Low Frequency Ratio

An Improved Model-Free Active Disturbance Rejection Deadbeat Predictive Current Control Method of PMSM based on Data-Driven