Abstract:Gafchromic EBT (EBT) films are becoming increasingly popular due to their advantageous properties. When flatbed colour scanners are used for film dosimetry, a good quality control of the scanning device is a crucial step for accurate results. The proposal of this work was to fully assess the performance of the scanner Epson Expression 10000XL in order to quantify all parameters and needed corrections to minimize dose uncertainties. A standard step tablet, with 32 steps and optical densities from 0.06 to 3.8, was used to check the scanner linearity. The scanner warming-up effect and reproducibility were evaluated by performing 30 consecutive scans plus 20 scans in 15 min intervals. The scanning colour modes: 24 and 48 bits and scanning resolutions from 50 to 300 dpi were tested. A Wiener filter with different pixels regions was applied with the purpose of reducing the film noise. All scans were made in transmission mode with a constant film orientation. The red colour channel was posteriorly extracted from the images to maximize readout sensitivity. Two EBT films were irradiated, perpendicularly and parallel to beam incidence, with a 6 MV photon beam with doses that ranged from 0.2 to 3 Gy. A polynomial expression was used to convert optical density into dose. Dose uncertainty was quantified applying error propagation analysis. A correction for the non-uniform response of the scanner was determined using five films irradiated with a uniform dose. The scanner response was linear until an optical density of approximately 1 which corresponds to doses higher than those of clinical interest for EBT films. The scanner signal stabilized after seven readings. Scanner reproducibility around 0.2% was obtained either with the scanner warm or cold. However, reproducibility was significantly reduced when comparing images digitized with the scanner at different temperatures. Neither the colour depth mode, the scanning resolution, the multiscan option nor the Wiener filter had a significant effect on the shape of the calibration curve. However, a reduction in dose uncertainty was possible by selecting appropriate reading parameters. These are a 48 bit colour depth, a 75 dpi resolution and repeating the scan four times. Finally, the two dimensional Wiener filter applied to a 3 x 3 pixel region to the red component of the image reduced the experimental scan uncertainty to about 0.5% for doses higher than 0.5 Gy. Total scan uncertainty was less than 2% for a perpendicular calibration and reduced to less than 1% for a parallel calibration. A dose over-estimation of around 5% for clinical doses may be made if the image acquired is not corrected for the non-uniform response of the scanner. A protocol to read EBT films using the Epson Expression 10000XL scanner was established for IMRT verification. The contribution for the overall uncertainty in film dosimetry coming from the scanning process was estimated to be around 0.5% for doses higher than 0.5 Gy when reading parameters are optimized. Total scan uncertainty achieved is about 2% when using a perpendicular calibration. It can further be reduced if a parallel calibration is used.

Universality class for extinction-survival phase transition in one dimension.

Evaluation of an Epson flatbed scanner to read Gafchromic EBT films for radiation dosimetry

Contrast Enhancement Based On Entropy And Reflectance Analysis For Surgical Lighting

Radiochromic film dosimetry with flatbed scanners: a fast and accurate method for dose calibration and uniformity correction with single film exposure

Purification, properties and inhibition of rat liver cytosolic vitamin B12-dependent methionine synthase.

The corticospinal tract in the kangaroo.

Optically stimulated luminescence system as an alternative for radiochromic film for 2D reference dosimetry in UHDR electron beams

Novel EBT3 film calibration using an integrated HSV color space analysis

Encephalopathy due to inorganic lead exposure in an adult.

Feasibility study of a portable and fast spatial dosimeter using an alcohol-based liquid scintillator and a digital camera

Technical note: Visual, rapid, scintillation point dosimetry for in vivo MV photon beam radiotherapy treatments

Gafchromic EBT2 film dosimetry in reflection mode with a novel plan-based calibration method

Deformable scintillation dosimeter I: challenges and implementation using computer vision techniques

Dosimetric characterization of a novel commercial plastic scintillation detector with an MR-Linac

Reading of gafchromic EBT-3 film using an overhead scanner

Investigation of self-adaptive LED surgical lighting based on entropy contrast enhancing method

Evaluation of a pixelated large format CMOS sensor for x-ray microbeam radiotherapy

Time-gated scintillator imaging for real-time optical surface dosimetry in total skin electron therapy

A comprehensive investigation of the performance of a commercial scintillator system for applications in electron FLASH radiotherapy

Assessment of LED’s Radiation Safety

Dosimetry of a novel converging X‐ray source for kilovoltage radiotherapy