Abstract:Periodic metal nanodisc arrays have the potential to exhibit regularly spaced large local field enhancements, especially when high-Q collective plasmonic grating resonances can be obtained. Here we demonstrate how Laser interference lithography (LIL) as a maskless and high throughput technique can be used to fabricate these on square centimeter areas. The drawback of LIL is the rather fixed ratio of the size of the individual nanostructure (d) to the period of the array (p) of about d/p ~ 0.5 for the setup used in the current article, thereby, limiting its ability to create resonances with ultra-high quality factors (Q-factors). To improve the Q-factor of the resonances of the arrays, we study the effect of thermal annealing nanodisk arrays fabricated by LIL and a lift off process. The nanodisk arrays with periods of 400 nm and 500 nm exhibited a plasmonic resonance, which was caused by the interaction of the single disk resonance and a (1 0) grating resonance. Annealing for a short duration lowered the d/p ratio from 0.5 to 0.4, and led to smoothening of the disk surfaces and growth of gold grains, resulting in lower ohmic and radiative losses and doubling of the Q-factor of the resonances. Finite element method (FEM) simulations were used to monitor this improvement in material parameters. Annealing for a longer duration disintegrated the nanodisk into several smaller particles while maintaining the overall periodicity of the array. While the plasmonic resonances of the experimentally investigated fragmented disks were basically destroyed, simulation predict that for larger periods fragmented nanodisk arrays (keeping the d/p ~ 0.4) can exhibit extremely strong and sharp resonances whose Q-factor increases more than 58.4 times compared to the unfragmented discs. In addition, simulations show a massive enhancement of the local electric field promising immense potential for surface enhanced Raman sensing.

E-page original images. Lev's disease: insidious enemy of conduction system.

Plasmonic Nano-Arrays for Ultrasensitive Bio-Sensing

Rational Design of On-Chip Refractive Index Sensors Based on Lattice Plasmon Resonances (presentation Recording)

Single-crystalline aluminum film for ultraviolet plasmonic nanolasers

Plasmonic Enhanced Photothermal Effects and Its Applications.

Study on Aluminum Concentration on Optical and Electrical Properties of AZO Thin Films Fabricated by Ultrasonic Spray Pyrolysis

Single-crystalline Aluminum Nanostructures on Semiconducting GaAs Substrate for Ultraviolet to Near-infrared Plasmonics

Enhanced Near Band Edge Emission of Zno Via Surface Plasmon Resonance of Aluminum Nanoparticles

Engineering of Parallel Plasmonic-Photonic Interactions for On-Chip Refractive Index Sensors

Effect of the annealing temperature on the refractive index and extinction coefficient of aluminum-doped zinc oxide: a low-cost electron transport layer

Tailoring ZnO Spontaneous Emission with Plasmonic Radiative Local Density of States Using Cathodoluminescence Microscopy

[Enhanced pathenogicity of chicken anemia agent (CAA) in dual infections with Marek's disease virus (MDV), infectious bursal disease virus (IBDV) or reticuloendotheliosis virus (REV)].

Dielectric nanocavity-coupled surface lattice resonances for high-efficiency plasmonic sensing

Tailoring Nanohole Plasmonic Resonance with Light-Responsive Azobenzene Compound.

ZnO-Au Hybrid Metamaterial Thin Films with Tunable Optical Properties

Plasmonic coupling effect of annealed gold nanoarrays

Tailoring core size, shell thickness, and aluminum doping of Au@AZO core@shell nanoparticles

Plasmonic Nanostructure Lattices for High‐Performance Sensing

Plasmonic Properties and Device in Nanostructures

Iron overload, hematopoietic cell transplantation, and graft-versus-host disease