Abstract:MXenes have attracted great attention as their potential applications in electrochemical and electronic devices due to their excellent characteristics. Traditional sound sources based on thermoacoustic effect demonstrated that a conductor needs to have an extremely low heat capacity and high thermal conductivity. Hence, a thin MXenes film with a low heat capacity per unit area (HCPUA) and special layered structure is emerging as a promising candidate to build loudspeakers. However, the using of MXenes in sound source device has not been explored. Herein, we have successfully prepared the sound source devices on anodic aluminum oxide (AAO) and flexible polyimide (PI) substrate by using the prepared Ti3C2 MXene nanoflakes. Due to the larger interlayer distance of MXene, the MXene-based sound source device has higher sound pressure level (SPL) than that of the same thickness graphene. High-quality Ti3C2 MXene nanoflakes were fabricated by selectively etching the Ti3AlC2 powder. The as-fabricated MXene sound source device on AAO substrate exhibits a higher SPL of 68.2 dB (f= 15 kHz), and has a very stable sound spectrum output with frequency vary from 100 Hz to 20 kHz. A theoretical model has been built to explain the mechanism of our sound source device on AAO substrate, matching well with the experimental results. Furthermore, the MXene sound source device based on flexible PI substrate has been attached to the arms, back of the hand, and fingers, indicating an excellent acoustic wearability. Then the MXene film is packaged successfully into a commercial earphone and shows an excellent performance at high frequencies, which is very suitable for human audio equipment. KEYWORDS: MXenes，Ti3C2，HCPUA，sound source device，earphone.

Thermoacoustic performance of 100 kHz wide-band packaged projector in water tank with three-dimensional graphene

A Real-Time 3-D Underwater Acoustical Imaging System

Flow Current Field Observation with Underwater Moving Acoustic Tomography

A Novel Thermal Acoustic Device Based on Porous Graphene

A Large-Scale and Low-Cost Thermoacoustic Loudspeaker Based on Three-Dimensional Graphene Foam.

Theory and experiment for 3D porous graphene foam thermoacoustic transducer

Thermoacoustic chips with carbon nanotube thin yarn arrays.

Experimental demonstration of three-dimensional broadband underwater acoustic carpet cloak

Graphene-Based Thermoacoustic Sound Source.

3-D Underwater Acoustic Wave Focusing by Periodic Structure

Analysis of Transient Thermoacoustic Characteristics and Performance in Carbon Nanotube Sponge Underwater Transducers

Suspended Graphene Hydroacoustic Sensor for Broadband Underwater Wireless Communications

High Efficiency and Low Distortion Photoacoustic Effect in 3D Graphene Sponge

Graphene-on-paper Sound Source Devices.

Experimental Demonstration of a Three-Dimensional Acoustic Hyperlens for Super-Resolution Imaging

Research on Frequency Doubling Effect of Thermoacoustic Speaker Based on Graphene Film

Surface Acoustic Wave Devices with Graphene Interdigitated Transducers

Hydroacoustic High Absorption with Broadband and Wide-Angle Impedance Matching

Graphene-Based Fully Transparent Thin Film Surface Acoustic Wave Devices for Sensing and Lab-on-Chip Applications

Three-Dimensional Finite Element Analysis and Characterization of Quasi-Surface Acoustic Wave Resonators

Flexible Two-Dimensional Ti3C2 MXene Films as Thermo-Acoustic Devices.