Insects as radar targets: size, form, density and permittivity
V. Alistair DrakeDjordje MirkovicMartin J. Steinbauera School of Science,The University of New South Wales,Canberra,Australian Capital Territory,Australiab Institute for Applied Ecology,University of Canberra,Canberra,Australian Capital Territory,Australiac Cooperative Institute for Severe and High-Impact Weather Research and Operations,University of Oklahoma,Norman,OK,USAd Department of Zoology,La Trobe University,Melbourne,Victoria,Australia
DOI: https://doi.org/10.1080/01431161.2024.2339203
IF: 3.531
2024-04-18
International Journal of Remote Sensing
Abstract:To make biologically useful interpretations of the echo signals from an entomological radar (a radar designed and operated to observe insects in flight), it is necessary to relate basic properties of insects (i.e. their mass, size, and form) to their radio-wave scattering characters – e.g. their radar cross-section (RCS) and its variation with aspect or beam polarization. Measurements of RCSs of live or freshly dead specimens in laboratory rigs have played an important role in establishing such relationships, but it is desirable to develop and validate methods employing numerical computation, using electromagnetic calculation software, as a more widely applicable and generalizable alternative. In such computations, the insect is represented by a model with specified size, form, and composition; composition appears as the complex relative permittivity, with both polarizability (real) and loss (imaginary) terms. As a preliminary to investigating how adequately different types of electromagnetic model perform, we have collected and analysed morphometric data on adult, flight-capable specimens of a wide range of insect species, including many known to be migratory and to fly at heights where they would be detectable by radar. Our analyses reveal that appropriate densities for prolate-spheroid models of flying insects are in the range 0.60–0.76 g cm −3 , which is about half that measured for air-free samples of the solids and liquids from which insect bodies are formed. From this, appropriate permittivities for the material filling the model are found to be in the range 7–11 (real component) and 2.0–3.5 (imaginary); again, these are much lower than measured values for pure insect-body material. These results enable construction of simple electromagnetic models of insects in which both spatial dimensions and masses are accurate. Computation of model RCSs and their aspect and polarization variations, and comparison of these with laboratory measurements, will be the topic of a follow-up validation study.
imaging science & photographic technology,remote sensing