Abstract:The present design practice of the bubble column reactors is still closer to an art than science because of the complexity of the fluid mechanics. In view of this, there have been continuous attempts to understand the complex three-dimensional turbulent two-phase flow. The present paper reviews the modelling efforts on the flow patterns published in the last 30 years with relatively more focus on the last 10 years. Over this period, there have been sustained efforts to improve our understanding of the governing equations of the change (equations of continuity and motion) for two-phase flows. Both Eulerian and Lagrangian approaches have been extensively used. The development has been mainly on three fronts: (i) formulation of interfacial forces (ii) closure problem for the eddy viscosity and (iii) modelling of the correlations arising out of Reynolds averaging procedure.As regards to interface force terms, the published literature has been critically analysed. The present status of our understanding of the drag force, virtual mass force and lift force has been presented. The physical significance of the various formulations has been brought out. The mechanism of the energy transfer from gas to liquid phase has been explained. The developments in closure problem have been most dramatic. The progress of the past 30 years has been reviewed with a focus on the past 10 years. The published literature has been critically analysed and chronology of development has been presented. The effort has been concentrated on cylindrical bubble columns where results on flow pattern could be extended to the design. The studies on transient flow pattern in two-dimensional columns have not been covered because the subject is still under development and the results cannot be extended to the design objective. The closure problem is intimately linked with the physics of turbulence.An attempt has been made to develop a complete correspondence between an operation of real column and the model simulation. Attention has been focused on the cylindrical bubble columns because of their widespread applications in the industry. The effects of the superficial gas velocity, column diameter and bubble slip velocity on the flow pattern have been examined. Extensive comparison has been presented between the predicted and the experimental velocity profiles.For the design of the bubble columns, the knowledge of various design parameters (such as pressure drop, rate of mixing, residence time distribution of both the phases, heat and mass transfer coefficients) is needed. For the estimation of these parameters, the prevailing procedures are largely empirical. The fundamental basis for the estimations is possible through the understanding of the detailed macro- and micro-flow patterns. This basic direction has been the subject of several publications, particularly during the last 5 years. All these studies have been critically analysed in the present review paper. A coherent and holistic approach has been presented on the modelling of fluid mechanics and design of bubble column reactors.Recommendations have been made for the future research in this area.

Gas—liquid flow in bubble columns and loop reactors: Part I. Detailed modelling and numerical simulation

Experimental and Numerical Investigations of Scale-Up Effects on the Hydrodynamics of Slurry Bubble Columns

CFD simulation of bubble column with vertical bundle internals

Experimental Investigation of Flow Development in Large-Scale Bubble Columns in the Churn-Turbulent Regime

2-D Hydrodynamic Model of Bubble Column Based on Lateral-Force Balance

Experimental and Numerical Simulation on Sequential Three Phase Jet-Loop Reactor

Novel Bubble–Emulsion Hydrodynamic Model for Gas–Solid Bubbling Fluidized Beds

CFD Simulation of Gas-Liquid Flow in Bubble Column

Gas Holdup and Liquid Velocity Distribution in a Jet Loop Reactor

Numerical Modelling of Bubbling Flow Dynamic Behaviour in a Bubble Column

Large-eddy Simulation of Gas–liquid Two-Phase Flow in a Bubble Column Reactor Using a Modified Sub-Grid Scale Model with the Consideration of Bubble-Eddy Interaction

Evolution and Interaction Characteristics of Liquid Flow and Bubbles in a Jet Bubbling Column

CFD Simulation of Gas-Liquid Flow in Bubble Column with Two-bubble Phase Population Balance Model

Modelling of Mass Transfer for Gas-Liquid Two-Phase Flow in Bubble Column Reactor with a Bubble Breakage Model Considering Bubble-Induced Turbulence

Numerical Simulations Of Fluid Dynamics And Mixing In A Large Shallow Bubble Column: Effects Of The Sparging Pipe Allocations For Multiple-Pipe Gas Distributors

Experimental Measurement and Theoretical Analysis on Bubble Dynamic Behaviors in a Gas-Liquid Bubble Column

Modelling and simulation of the dynamic flow behaviour in a bubble column

Numerical description of flow regime transitions in bubble column reactors by a multiple gas phase model

Computational flow modelling and design of bubble column reactors

Three-Phase Liquid-Gas-Solid Flows in a Bubble Column

Euler/Lagrange Calculations of Gas-Liquid-Solid-Flows in Bubble Columns with Phase Interaction