Abstract:Attempts to electrocatalytically upgrade bio-oil have been made in recent years. Mostly, the ECH (Electrocatalytic Hydrogenation) experiments of bio-oil were done using fixed bed electrode configurations at room temperatures and low current densities (<100 cm -2 ). The main goal was to demonstrate the viability of ECH as a bio-oil stabilization strategy, mainly through reduction of carbonyl contents (aldehydes and ketones) which could cause polymerization. High temperature may promote condensation polymerization of fast pyrolysis oil, low-temperature ECH is therefore considered a promising approach to stabilize pyrolysis oil. However, recent advances in ECH of fast pyrolysis oil have shown the limited reductive upgrading chemistry (hydrogenation, hydrogenolysis, or hydrodeoxygenation) through this approach. This was mainly attributed to the complexity of fast pyrolysis oil and the restricted electrolysis operating conditions. Most of the published works in ECH of pyrolysis oil reported the reduction of carbonyl content into alcohols in the substrate rather than the hydrodeoxygenation of aromatics or phenolics. In this study, ECH of fast pyrolysis oil (FPO) in acidic electrolytes using SSER (Stirred Slurry Electrocatalytic Reactor) configuration was conducted for the first time. A compositional analysis suggested that the FPO sample contained water (29 wt.%) and detected monomers (38.5 wt.%), which comprise of carbohydrate derivatives (35.2 wt.%) and lignin derivatives (3.3 wt.%). Balance of water and monomers must be oligomers. Three polar organic solvents (e.g., ethanol, isopropanol, and acetone) were tested in a mixed aqueous and organic electrolyte with MSA solution. The electrolysis experiments were carried out for 4–30 h at constant cathodic current densities (I = -218 to -255 mA cm -2 ) and temperatures (50–60 o C). In all cases, decreases in the weight average molecular weight (Mw) and the number average molecular weight (Mn) were observed with prolonged reaction times. Temperature and catalyst loading contributed to faster depolymerization of the oligomers. Using different organic solvents (e.g., ethanol, isopropanol, acetone), the degree of depolymerization was about 33–37% after nearly 20 h reactions. Color changes in the catholyte FPO samples were observed in all cases after 18–25 h, turning from dark brown to light yellow. This observation supports the GPC results showing the molecular weight reduction after the ECH. In this study, compound distributions were determined based on ten functional groups, such as acids, alcohols, aldehydes, ketones, esters, furans, alkanes, aromatics, phenols, and guaiacols. In all cases, the reduction of ketones, aromatics, and guaiacols was noticed, while the alkanes content slightly increased. The most dramatic increases in esters content were observed when ethanol (17–25%) or isopropanol (19–32%) was used. This was attributed to esterification of carboxylic acids (mainly acetic acid) in the FPO with alcohols in the presence of MSA, which catalyzed the reaction. Reduction of p-eugenol to cerulignol (4-propylguaiacol) was the most noticeable in all cases, implying that the unsaturated bond in the allyl group is easily reduced under the ECH conditions. Significant increases in the cerulignol contents were achieved with all the different solvents: ethanol (0.5–4.9%), isopropanol (1.4–6.9%), and acetone (1.4–5.4%), based on the composition calculation normalized by the lignin-relevant compounds detected in the catholyte samples. ECH of FPO in SSER with organic solvents addition has demonstrated mild depolymerization of FPO oligomers, esterification, and reduction of carbohydrate and lignin derivative monomers which could potentially upgrade the quality of FPO for synthesis of hydrocarbon fuels.

Impact of Macroporosity on Catalytic Upgrading of Fast Pyrolysis Bio-Oil by Esterification over Silica Sulfonic Acids

Catalytic Conversion Of Bio-Oil To Oxygen-Containing Fuels By Acid-Catalyzed Reaction With Olefins And Alcohols Over Silica Sulfuric Acid

Study on Upgrading of Bio-Oil Catalyzed over Solid Acids

Catalytic pyrolysis of bio-oil model compounds over La/P/Ni modified ZSM-5

Catalytic Upgrading Of Bio-Oil Using 1-Octene And 1-Butanol Over Sulfonic Acid Resin Catalysts

Upgrading of Liquid Fuel from the Vacuum Pyrolysis of Biomass over the Mo–Ni/γ-Al2O3 Catalysts

Influence of the Feedstock on Catalytic Fast Pyrolysis with a Solid Acid Catalyst

Catalytic Upgrading of Bio-Oil by Reacting with Olefins and Alcohols over Solid Acids: Reaction Paths Via Model Compound Studies

Catalytic Esterification of Model Compounds of Biomass Pyrolysis Oil

Improvement of Properties of Bio-Oil from Biomass Pyrolysis in Auger Reactor Coupled to Fluidized Catalytic Bed Reactor

Comparative Production of Bio-Oil from In Situ Catalytic Upgrading of Fast Pyrolysis of Lignocellulosic Biomass

Production of Phenolic-Rich Bio-Oil from Catalytic Fast Pyrolysis of Biomass Over Tailored Fe-Based Catalysts

Optimization of process variables for esterification of bio-oil model compounds by a heteropolyacid catalyst

One-step hydrogenation-esterification of aldehyde and acid to ester over bifunctional Pt catalysts: A model reaction as novel route for catalytic upgrading of fast pyrolysis bio-oil

On the influence of Si:Al ratio and hierarchical porosity of FAU zeolites in solid acid catalysed esterification pretreatment of bio-oil

Electrocatalytic Upgrading of Biomass Fast Pyrolysis Oil

Upgrading of the Liquid Fuel from Fast Pyrolysis of Biomass over MoNi/γ-Al2O3 Catalysts

Catalytic Fast Pyrolysis of Lignocellulosic Biomass: Recent Advances and Comprehensive Overview

Experimental Research on Catalytic Esterification of Bio-Oil Volatile Fraction

A Review of Recent Research on Catalytic Biomass Pyrolysis and Low-Pressure Hydropyrolysis

Upgrading of bio-oil over bifunctional catalysts in supercritical monoalcohols