Abstract:Greywater is an attractive source for water reuse at the household or building level, particularly for non-potable applications. Two greywater treatment approaches are membrane bioreactors (MBR) and moving bed biofilm reactors (MBBR), yet, their performance has not been compared so far within their respective treatment flowsheets, including post-disinfection. Two lab-scale treatment trains were operated on synthetic greywater: a) MBR with either polymeric (chlorinated polyethylene, C-PE, 165 days) or ceramic (silicon carbide, SiC, 199 days) membranes coupled with UV disinfection; and b) single-stage (66 days) or two-stage (124 days) MBBR coupled with an electrochemical cell (EC) for in-situ disinfectant generation. Water quality was constantly monitored, and Escherichia coli log removals were assessed through spike tests. Under low-flux operation of the MBR (<8 L·m - 2·h - 1), the SiC membranes delayed the onset of membrane fouling and needed less frequent cleaning compared to C-PE membranes. Both treatment systems met most water quality requirements for unrestricted greywater reuse, at a 10-fold lower reactor volume for the MBR than the MBBR. However, neither the MBR nor the two-staged MBBR allowed adequate nitrogen removal, and the MBBR did not consistently meet effluent chemical oxygen demand and turbidity requirements. Both EC and UV provided non-detectable E. coli concentrations in the effluent. Although the EC provided residual disinfection, scaling and fouling decreased its energetic and disinfection performance over time, making it less efficient than UV disinfection. Several outlines to improve the performance of both treatment trains and disinfection processes are proposed, thus, allowing a fit-for-use approach that leverages the advantages of the respective treatment trains. Results from this investigation will assist in elucidating the most efficient, robust, and low-maintenance technology and configurations for small-scale greywater treatment for reuse.

Greywater characterization and loadings - Physicochemical treatment to promote onsite reuse

Quality of individual domestic greywater streams and its implication for on-site treatment and reuse possibilities

Treatment of household grey water with a UF membrane filtration system

Performance of a Micro-Scale Membrane Reactor for Greywater Treatment at Household Level

Use of green roofs for greywater treatment: Role of substrate, depth, plants, and recirculation

Management of greywater: environmental impact, treatment, resource recovery, water recycling, and decentralization

Chemical Solutions for Greywater Recycling

Quantitative Microbial Risk Assessment of Greywater On-Site Reuse.

Treatment of greywater and presence of microplastics in on-site systems

Comparison of MBR and MBBR followed by UV or electrochemical disinfection for decentralized greywater treatment

Converting treatment wetlands into "treatment gardens": Use of ornamental plants for greywater treatment

Green walls for greywater treatment: a comprehensive review of operational parameters and climate influence on treatment performance

Reuse Status and Technology Research of Residential Grey Water

Low strength graywater characterization and treatmentby direct membrane filtration

Current status in wastewater treatment, reuse and research in some mediterranean countries

Towards Sustainable Homes: Exploring Point-of-Use Treatment for Laundry Water Recycling

Designing slanted soil system for greywater treatment for irrigation purposes in rural area of arid regions

Load and distribution of organic matter and nutrients in a separated household wastewater stream

Treatment of greywater using a non-aerated combined horizontal and vertical flow constructed wetland

Reduction of pathogens in greywater with biological and sustainable treatments selected through a multicriteria approach

Stream Segregation in Household Use: A Review of Grey Water as an Alternative Source of Water and Yellow Water as an Alternative Source of Fertilizers