Abstract:With the conventional mechanical rotation measurement of joints, only static measurements are possible with the patient at rest. In the future, it would be interesting to carry out dynamic rotation measurements, for example, when walking or participating in sports. Therefore, a measurement method with an elastic polymer-based capacitive measuring system was developed and validated. In our system, the measurement setup was comprised of a capacitive strain gauge made from a polymer, which was connected to a flexible printed circuit board. The electronics integrated into the printed circuit board allowed data acquisition and transmission. As the sensor strip was elongated, it caused a change in the spacing between the strain gauge's electrodes, leading to a modification in capacitance. Consequently, this alteration in capacitance enabled the measurement of strain. The measurement system was affixed to the knee by adhering the sensor to the skin in alignment with the anterolateral ligament (ALL), allowing the lower part of the sensor (made of silicone) and the circuit board to be in direct contact with the knee's surface. It is important to note that the sensor should be attached without any prior stretching. To validate the system, an in vivo test was conducted on 10 healthy volunteers. The dorsiflexion of the ankle was set at 2 Nm using a torque meter to eliminate any rotational laxity in the ankle. A strain gauge sensor was affixed to the Gerdii's tubercle along the course of the anterolateral ligament, just beneath the lateral epicondyle of the thigh. In three successive measurements, the internal rotation of the foot and, consequently, the lower leg was quantified with a 2 Nm torque. The alteration in the stretch mark's length was then compared to the measured internal rotation angle using the static measuring device. A statistically significant difference between genders emerged in the internal rotation range of the knee (p = 0.003), with female participants displaying a greater range of rotation compared to their male counterparts. The polymer-based capacitive strain gauge exhibited consistent linearity across all measurements, remaining within the sensor's initial 20% strain range. The comparison between length change and the knee's internal rotation angle revealed a positive correlation (r = 1, p < 0.01). The current study shows that elastic polymer-based capacitive strain gauges are a reliable instrument for the internal rotation measurement of the knee. This will allow dynamic measurements in the future under many different settings. In addition, significant gender differences in the internal rotation angle were seen.

Influence of age and gender on normative passive range of motion values of the carpometacarpal joint of the thumb

The Female Thumb Carpometacarpal Joint: Motion and Force Changes Due to Arthritis and Surgical Intervention

The passive biomechanics of the thumb carpometacarpal joint: An in vitro study

Kinematic Investigation of Healthy, Arthritic, and Postsurgery Thumbs: Is the Metacarpophalangeal Joint the Gateway to Carpometacarpal Arthritis?

Do osteophytes alter thumb carpometacarpal Biomechanics? a preliminary in vitro study

Range of Motion of the Upper Extremity in a Healthy Pediatric Population: Introduction to Normative Data

Comparing Isolated Thumb Force Generation, Wrist Rotation, and Clinical Measurements in Healthy and Osteoarthritic Individuals before and after Surgery

Association between the Range of Motion and Passive Property of the Gastrocnemius Muscle-Tendon Unit in Older Population

Minimal detectable difference of the finger and wrist range of motion: comparison of goniometry and 3D motion analysis

Three-Dimensional Analysis of the First Metacarpal Axes in Healthy Individuals and Early-Stage Thumb Carpometacarpal Osteoarthritis Patients—Potential Implication on First Metacarpal Corrective Osteotomy

Normative Data of Carpal Bone Measurements in the Sample Adult Indian Population

Physiotherapeutic Approaches in Thumb Carpometacarpal Joint Arthritis for Pain, Function, and Grip Strength

Impact of chronic wrist hypermobility on proprioception, strength, and functional performance in young adults

The Relationship between Structure of the Wrist and Function in a Japanese and Caucasian Population

Internal Rotation Measurement of the Knee with Polymer-Based Capacitive Strain Gauges versus Mechanical Rotation Measurement Taking Gender Differences into Account: A Comparative Analysis

Development of normative data for hand strength and anthropometric dimensions in a population of automotive workers

Movement analysis of the distal transverse arch of the dominant hand while grasping and pinching objects: A descriptive, correlational research study

The relation between synovitis of individual finger joints and grip force over the first 5 years in early rheumatoid arthritis - a cohort study

Postoperative Radiographic Outcomes Following Abduction-Extension Metacarpal Osteotomy: A Comparison between Early and Advanced Carpometacarpal Arthritis

How is range of motion of the fingers measured in hand therapy practice? A survey study

Development of an implantable trapezium carpal bone replacement for measuring in vivo loads at the base of the thumb