Abstract:Wind Engineering, Ahead of Print. In the current work we experimentally explored yawed wind turbine wake impacts on downwind wind turbine performances and wind loads. The lab-scale wind turbine model with a rotor diameter (D) of 0.442 m and a height of 1 m (=2.26D) was installed in a closed-circuit boundary layer wind tunnel (test section: 15 m long × 3.6 m wide × 2.0 m high) of the Research Institute for Applied Mechanics (RIAM) of Kyushu University. Power performance tests were initially conducted with a single rotor in isolation in order to characterize a rotor's power output in stand-alone conditions. A detailed comparison of the tests revealed that the power output decreased rapidly as the yaw angle (γ) increased. It is presumed that the power output decrease in yawed cases is mainly due to the decrease in the effective rotor area and the change in the angle of the incoming wind flow with respect to the wind turbine blade. Next, using two wind turbine models aligned with the dominant inflow direction, the merging wakes behaviors caused by three different lateral separation distances were tested: (a) Case 1 (y = 0), (b) Case 2 (y = 0.5D), and (c) Case 3 (y = 1D). Here, the separation distance between the two wind turbine models was fixed at 6D in all cases. Extremely large power output deficits of 46%–76% were seen in the Case 1 configuration. This is mainly due to the significant wake velocity deficits induced by the upwind wind turbine model. In the Case 2 configuration with γ values of 20° and 30°, a significant increase in the power output of the downwind wind turbines was observed. Similar to Case 1 configuration, these results are considered to be mainly due to the upwind turbine-induced wake velocity deficits and wake deflection. Finally, in the Case 3 configuration, no significant difference was found in all of the results, and the tendency was almost the same. We show that the wake velocity deficits induced by the upwind wind turbine model had almost no effect on the power output of the downwind wind turbine model. We evaluated the total power output of the two turbines. As a result, in the Case 2 configuration with 20° yaw angle, the total power output of the two wind turbine models was the highest due to the increase in the power output of the downwind wind turbine model. In order to investigate the main cause of the significant increase in the power output of the downwind wind turbine model at 20° and 30° yaw angles in the Case 2 configuration, we measured the lateral wind speed distribution at the 6D position on the downwind side of the upwind wind turbine model by using the ultrasonic anemometer. As a results, it was clarified that the peak of the wake velocity deficits induced by the upwind wind turbine model is clearly shifted away from the downwind turbine such that it experiences a smaller deficit due to wake steering. Also, with wake steering the upwind turbine-induced wake velocity deficits may be smaller due to the reduction in rotor area. Finally, it is extremely important to understand the wind load acting on the downwind wind turbine model operating within the wake region induced by the upwind yawed wind turbine model when the maximum power output is generated. It can be seen that as the yaw angle of the upwind wind turbine model increased, the power output generated by the downwind wind turbine model and the streamwise wind load acting on it also increased. However, it was also clarified that the streamwise wind load acting on the downwind wind turbine model in this situation did not exceed the stand-alone value.

Influence of wind direction on flow over a cliff and its interaction with a wind turbine wake

Effects of continuously changing inlet wind direction on near-to-far wake characteristics behind wind turbines over flat terrain

Effects of incoming surface wind conditions on the wake characteristics and dynamic wind loads acting on a wind turbine model

Wind tunnel study of the wind turbine interaction with a boundary-layer flow: Upwind region, turbine performance, and wake region

Coriolis effects on wind turbine wakes across atmospheric boundary layer regimes

Wake dynamics of wind turbines in unsteady streamwise flow conditions

An experimental and analytical study of wind turbine wakes under pressure gradient

Wind turbine wake superposition under pressure gradient

Analyzing the Effects of Atmospheric Turbulent Fluctuations on the Wake Structure of Wind Turbines and Their Blade Vibrational Dynamics

The influence of freestream turbulence on the development of a wind turbine wake

Numerical analysis of aero-hydrodynamic wake flows of a floating offshore wind turbine subjected to atmospheric turbulence inflows

Numerical Analysis of Atmospheric Turbulence Effects on Wind Turbine

Application of the Townsend–George theory for free shear flows to single and double wind turbine wakes – a wind tunnel study

The Aerodynamic Performance of Horizontal Axis Wind Turbines under Rotation Condition

Exploring Inflow Wind Condition on Floating Offshore Wind Turbine Aerodynamic Characterisation and Platform Motion Prediction Using Blade Resolved CFD Simulation

A Wind Tunnel Experimental Study on the Wake Characteristics of a Horizontal Axis Wind Turbine

Flow Separation Control and Aeroacoustic Effects of a Leading-Edge Slat over a Wind Turbine Blade

A wind tunnel investigation of yawed wind turbine wake impacts on downwind wind turbine performances and wind loads

Investigation of the Wake Propagation Behind Wind Turbines over Hilly Terrain with Different Slope Gradients

Diagonal Inflow Effect on the Wake Characteristics of a Horizontal Axis Wind Turbine with Gaussian Model and Field Measurements

Wind Tunnel Study of a “Floating” Wind Turbine’s Wake in an Atmospheric Boundary Layer with Imposed Characteristic Surge Motion