The Effect of Sharklet Patterns on Thermal Efficiency and Salt-Scaling Resistance of Poly (vinylidene fluoride) Membranes During Direct Contact Membrane Distillation

Shouhong Fan,Duong T. Nguyen,Jaylene Martinez,John Chau,Kieran Fung,Kamalesh Sirkar,Anthony P. Straub,Yifu Ding

DOI: https://doi.org/10.1016/j.memsci.2024.123476

IF: 9.5

2024-11-11

Journal of Membrane Science

Abstract:Membrane distillation (MD) can treat high-salinity brine. However, the system's efficiency is hindered by obstacles, including salt scaling and temperature polarization. When properly implemented, surface patterns can improve the mass and heat transfer in the boundary layer, which leads to higher MD efficiency. In this work, the performance of direct contact membrane distillation (DCMD) using Sharklet-patterned poly (vinylidene fluoride) (PVDF) membranes is investigated. Both non-patterned and patterned PVDF membranes are prepared by lithographically templated thermally induced phase separation ( lt -TIPS) process with optimized conditions. Sharklet patterns on the membranes improve the DCMD performance: up to 17 % higher water flux and 35 % increased brine-side heat transfer coefficient. The scaling resistance of the membranes during DCMD is tested by both saturated CaSO 4 solution and hypersaline NaCl solutions. Patterned PVDF membranes show an average of 30 % higher water flux and up to 45 % lessened flux decline over time compared with non-patterned membranes when treating high-concentration brines. Post-mortem analysis reveals that Sharklet-patterned membranes display less salt-scaling on surfaces with smaller-sized CaSO 4 and NaCl crystals, maintain a relatively cleaner surface, and exhibit better retention of hydrophobicity.

engineering, chemical,polymer science