OFH - Characterization and application of transmission fiber

LA. de Montmorillon,P. Sillard,M. Astruc-Bigot,Balmefrezol
DOI: https://doi.org/10.1109/ofc.2005.193110
Abstract:Transmission fiber, optimized for metropolitan applications, is realized and tested in typical system configuration. It offers a low dispersion and slope for broadband, uncompensated reach, while maintaining large effective area to suppress detrimental non-linear effects, 02005 Optical Society of America WlS codes: (060.2280) Fiber design and fabrication; (060.4510) Optical communications Draka Comteq. an AlcateUDraku Compav, 53 rue Jem Broufin. 78 700 Contms Soinre-Honorine. Frunce Tel : +33(0)139191229; e-mail : louir_ortne.de_monnnori l lo~l~~el .~ Alcatel Research & Innovdion. Route de Nmq> 91460 marc ours^, Frunce Introduction Optical communication systems are characterized by ever increasing capacity, flexibility, cost constraints and transmission distances. Depending on the type of application under consideration, optimum choices in fiber parameters are different. For metropolitan applications, constraints on flbers are related to overall system cost ismes and flexibility, with the need to accommodate for future growth. Non-Zero Dispersion-Shifted Fibers, NZ-DSFs, with a moderate amount of dispersion at 155Onm appear as very good candidates, since they allow to bridge distances up to 200km or more without costly dispersioncompensating modules, DCMs. Both fibers with negative and positive dispersion have been developed over the last few years [1-5]. However, negative dispersion fibers are only optimized for very specific applications using Directly Modulated Lasers with positive chirp. System requirements also impose constraints on both dispersion and effective area over a wide wavelength range, making the achievable trade-off between dispersion, dispersion slope and effective =ea a key attribute for metropolitan fibers. In this paper, we present a NZ-DSF optimized for metropolitan applications with positive dispersion of 5pslm-km and reduced dispersion dope of 0.028ps/nmZ-km We also report an effective area of 54pm2, which is the highest value ever reported for such low dispersion and slope. We then demonstrate successful transmission experiments in typical metropolitan configuration. Fiber Characteristics Metropolitan-network systemdesign strategy greatly differs fiom that of longand ultra long-haul. Low cost is an essential parameter that drives metropolitan system design. It pushes for a large variety of operating wavelength: at 13lOnm to be compatible with legacy systems working with price-competitive laser diodes; and over the lowestattenuation bands: S(1460-15301~11) + C(1530-1570nm) + L(1570-1625nm). Externally-modulated sources, DCMs, and costly regeneration cards at receiver side should also be avoided since they greatly impact on the,overall system cost. DCMs are not only costly but strongly impact the loss budget and may lead to additional amplification devices. Fibers with reduced dispersion value are necessary since typical maximum cumulated dispersion in the range of 1200-16OOps/nm for l0Gbls rates is allowed over S+C+L bands, when using low-cost KM (Integrated Laser Modulator) sources and lowcost regeneration card Finally, single-mode operation and low absolute value of dispersion in the 0-band (1260-1 360m) are also required. Considering such a transmission environment, we computed that a dispersion between +2 and +Xps/nm-km over the S+C+L transmission bands is required, thus leading to stringent constraints on dispersion slope. An effective area, &, over 50pm2 is also mandatory to overcome both intraand inter-channel non-linear effects that are still present in DWDM noncompensated systems. , q p-;,
What problem does this paper attempt to address?