Emission, distribution and formation characteristics of polybrominated dibenzo- p -dioxins and dibenzofurans during co-disposal of hexabromocyclododecane-containing waste in cement kiln

Jian Wang,Bingcheng Lin,Xiao Wang,Guorui Liu,Rong Jin,Jukun Xiong,Jianping Guo,Yinming Li,Minghui Zheng
DOI: https://doi.org/10.1016/j.scitotenv.2024.176168
IF: 9.8
2024-09-15
The Science of The Total Environment
Abstract:Hexabromocyclododecane (HBCD)-containing waste was co -disposed in a cement kiln to evaluate its destruction removal efficiency (DRE) and its impact on polybrominated dibenzo- p -dioxins and dibenzofurans (PBDD/Fs) formation. The DRE of HBCD exceeded 99.9999 %. The residual HBCD after disposal was mainly found in kiln head ash and clinker. Stack gas at kiln head and tail exhibited average PBDD/Fs emission levels (sum of 13 2,3,7,8-PBDD/Fs congeners) of 0.36 and 0.42 ng m −3 , respectively, with octa-BDD predominating. However, in the kiln tail ash, hexaBDF and hepta-BDF were secondarily generated, leading to an increase in PBDFs concentration. Notably, most HBCD underwent debromination and ring-opening in the calciner, with released bromine absorbed and removed by CaO. Its decomposition products such as polycyclic aromatic hydrocarbons, biphenyls and their derivatives served as carbon sources for PBDD/Fs synthesis. However, co-disposal of HBCD did not significantly raise PBDD/Fs emissions but altered their homolog distribution from PBDDs to PBDFs. Emission factors of HBCD and PBDD/Fs were the highest in the clinker at 6.55 × 10 2 and 0.55 × 10 2 μg t −1 , respectively. Therefore, attention was needed for the potential secondary release of pollutants during the transportation and utilization of clinker. These findings enhanced understanding of the distribution and formation pathways of PBDD/Fs during cement kiln co-processing, providing insights for their source control.
environmental sciences
What problem does this paper attempt to address?