Abstract:Silicon (Si) has attracted worldwide attention for its ultrahigh theoretical storage capacity (4200 mA h g−1), low mass density (2.33 g cm−3), low operating potential (0.4 V vs. Li/Li+), abundant reserves, environmentally benign nature, and low cost. It is a promising high-energy-density anode material for next-generation lithium-ion batteries (LIBs), offering a replacement for graphite anodes owing to the escalating energy demands in booming automobile and energy storage applications. Unfortunately, the commercialization of silicon anodes is stringently hindered by large volume expansion during lithiation–delithiation, the unstable and detrimental growth of electrode/electrolyte interface layers, sluggish Li-ion diffusion, poor rate performance, and inherently low ion/electron conductivity. These present major safety challenges lead to quick capacity degradation in LIBs. Herein, we present the synergistic effects of nanostructured silicon and SrTiO3 (STO) for use as anodes in Li-ion batteries. Si and STO nanoparticles were incorporated into a multiwalled carbon nanotube (CNT) matrix using a planetary ball-milling process. The mechanical stress resulting from the expansion of Si was transferred via the CNT matrix to the STO. We discovered that the introduction of STO can improve the electrochemical performance of Si/CNT nanocomposite anodes. Experimental measurements and electrochemical impedance spectroscopy provide evidence for the enhanced mobility of Li-ions facilitated by STO. Hence, incorporating STO into the Si@CNT anode yields promising results, exhibiting a high initial Coulombic efficiency of approximately 85%, a reversible specific capacity of ~800 mA h g−1 after 100 cycles at 100 mA g−1, and a high-rate capability of 1400 mA g−1 with a capacity of 800 mA h g−1. Interestingly, it exhibits a capacity of 350 mAh g−1 after 1000 lithiation and delithiation cycles at a high rate of 600 mA hg−1. This result unveils and sheds light on the design of a scalable method for manufacturing Si anodes for next-generation LIBs.

Silicon/Carbon Nanotube/BaTiO₃ Nanocomposite Anode: Evidence for Enhanced Lithium-Ion Mobility Induced by the Local Piezoelectric Potential

In Situ Synthesis of Carbon Doped Porous Silicon Nanocomposites As High-Performance Anodes for Lithium-Ion Batteries.

Nanocomposites As Anode for Lithium-Ion Battery

Pseudocapacitance-Enhanced Li-Ion Microbatteries Derived by a TiN@TiO2 Nanowire Anode

Silicon/Carbon Nanoparticles Assembled with Multifunction Carbon Nanotubes/Sheets as High-Performance Anode of Lithium-Ion Batteries

Nano-silicon embedded in MOFs-derived nitrogen-doped carbon/cobalt/carbon nanotubes hybrid composite for enhanced lithium ion storage

Conjugation with carbon nanotubes improves the performance of mesoporous silicon as Li-ion battery anode

Meso-porous silicon-coated carbon nanotube as an anode for lithium-ion battery

Arrays of Sealed Silicon Nanotubes As Anodes for Lithium Ion Batteries

Enhancing Electrochemical Performance of Si@CNT Anode by Integrating SrTiO3 Material for High-Capacity Lithium-Ion Batteries

Building sandwich-like carbon coated Si@CNTs composites as high-performance anode materials for lithium-ion batteries

Si/C Composite Embedded Nano-Si in 3D Porous Carbon Matrix and Enwound by Conductive CNTs As Anode of Lithium-Ion Batteries

Si/Ti3SiC2 Composite Anode with Enhanced Elastic Modulus and High Electronic Conductivity for Lithium-Ion Batteries

Nanostructured Si/TiC Composite Anode for Li-ion Batteries

Electrochemical performance of a high-performance SiO composite anode material for Li-ion battery enhanced by piezoelectric effect

Three-Dimensional Porous Si and SiO2 with In Situ Decorated Carbon Nanotubes As Anode Materials for Li-ion Batteries

Electrolytic preparation of porous TiSi2/Si nanocomposites and the electrochemical performances as lithium-ion battery anode

In situ TEM study of lithiation behavior of silicon nanoparticles attached to and embedded in a carbon matrix

CNTs-intertwined and N-doped porous carbon wrapped silicon anode for high performance lithium-ion batteries

TiO2(B)@carbon Composite Nanowires As Anode for Lithium Ion Batteries with Enhanced Reversible Capacity and Cyclic Performance

Si@C Core–Shell Nanostructure-Based Anode for Li-Ion Transport