Abstract:OBJECTIVE:To investigate the changes of the vertical height and width of the alveolar bone six months after the alveolar ridge preservation in periodontal compromised molar sites of severe alveolar bone defects with clinical direct measurement, parallel periapical radiographs, and cone-beam computed tomography (CBCT), and to analyze the effect of the three different methods of measurement. METHODS:In this study, 20 subjects requiring tooth extraction on account of periodontal disease with a total of 23 extracted molars were enrolled. Extractions were performed atraumatically and patients were received alveolar ridge preservation procedure with Bio-Oss and Bio-Gide. Clinical direct measurements were taken after tooth extraction and during the implant surgery 6 months later, CBCT scans and parallel periapical radiographs were taken immediately after ridge preservation and 6 months later. The changes of alveolar ridge width and vertical height after six months were measured and analyzed through the above-mentioned three methods and the similarities and differences of the measured effect were compared. RESULTS:There were no significant difference of alveolar vertical height in the center of the extraction sites, the center of distal aspect, and distobuccal aspect between the clinical direct measurements and the CBCT measurements (P>0.05), alveolar vertical height in other points and alveolar width measurements were statically significant (P<0.05). After 6 months, 10 sites of 10 subjects were received a flap and re-entered to perform dental implants surgery. The vertical height in the center of alveolar increased significantly and the changes of alveolar vertical height of clinical direct and CBCT measurement were (6.15 ± 1.73) mm and (6.59 ± 2.53) mm, respectively. The measurements of the width of the alveolar bone were (8.45 ± 1.18) mm and (8.52 ± 1.27) mm, respectively. The measurements of the two methods were not statistically significant (P>0.05). The change of the alveolar height in the center of the extraction socket after six months measured by parallel periapical was (5.84 ± 4.28) mm, which was closed to the clinical direct measurement and the CBCT measurement. CONCLUSION:Clinical direct measurement and CBCT measurement were largely consistent in the evaluation of the alveolar bone height and width after the alveolar ridge preservation using deproteinized boving bone mineral (DBBM, Bio-Oss) and bioabsorbable collagen membrane (Bio-Gide) in periodontal compromised molar sites of severe bone defects.

[Application of xenograft for alveolar ridge preservation in posterior sites: a randomized controlled clinical trial]

Combined use of xenogeneic bone substitute material covered with a native bilayer collagen membrane for alveolar ridge preservation: A randomized controlled clinical trial.

The impact of autologous concentrated growth factors on the alveolar ridge preservation after posterior tooth extraction: A prospective, randomized controlled clinical trial

[Radiographic Evaluation of Ridge Preservation after Molar Tooth Extraction: a Controlled Clinical Trial].

Alveolar Ridge Preservation Using a Collagenated Xenograft: A Randomized Clinical Trial

Soft tissue contour and radiographic evaluation of ridge preservation in early implant placement: A randomized controlled clinical trial

Preservation of Alveolar Ridge using Graft Material after Tooth Extraction: A Clinical Trial

Preservation and Augmentation of Molar Extraction Sites Affected by Severe Bone Defect Due to Advanced Periodontitis: A Prospective Clinical Trial

Clinical applications of concentrated growth factors combined with bone substitutes for alveolar ridge preservation in maxillary molar area: a randomized controlled trial

Ridge preservation in maxillary molar extraction sites with severe periodontitis: a prospective observational clinical trial

Clinical Study of Tissue Preservation of Extraction Socket with Bio-Oss Collagen and Acellular Dermal Matrix

Histological Evaluation of Alveolar Ridge Preservation Using Different Bone Grafts: Clinical Study Analysis Part II

The effect of different soft-tissue management techniques for alveolar ridge preservation: a randomized controlled clinical trial

Influence of preservation of the alveolar ridge on delayed implants after extraction of teeth with different defects in the buccal bone

Efficacy of Autogenous Dentin Biomaterial on Alveolar Ridge Preservation: A Randomized Controlled Clinical Trial

[Evaluation with Different Measuring Methods for the Alveolar Bone Change of Ridge Preservation in Molar Sites].

Three-dimensional analysis of bone remodeling following ridge augmentation of compromised extraction sockets in periodontitis patients: A randomized controlled study

Evaluation of Alveolar Ridge Dimensions by Socket Preservation Therapy Using a Bone Graft and Platelet-Rich Fibrin: A Randomized Controlled Trial

Alveolar ridge preservation in post-extraction sockets using concentrated growth factors: a split-mouth, randomized, controlled clinical trial

The Assessment of Volumetric Changes for Alveolar Ridge Preservation or Reconstruction by Three-dimensional Analysis at Posterior Extraction Sites with Severe Bone Defects Using DBBM-C Collagen Membrane and PRF: A Prospective and Randomized Clinical Trial

Alveolar ridge preservation with fibroblast growth factor-2 modified acellular dermal matrix membrane and a bovine-derived xenograft: An experimental in vivo study