3D digital rock modeling of the fractal properties of pore structures

Miao Luo,Paul W.J. Glover,Peiqiang Zhao,Dong Li

DOI: https://doi.org/10.1016/j.marpetgeo.2020.104706

IF: 5.361

2020-12-01

Marine and Petroleum Geology

Abstract:<p>Fractal parameters of porous media have been a focus of study in petroleum engineering and hydrogeology for several decades because they provide an effective way to describe the complexity of pore structure across a wide range of scales. This paper combines 3D process-driven digital rock modeling with fractal analysis in order to understand the effect of varying sorting, compaction, cementation, and the fine grain fraction of binary models on the fractal parameters and specific surface area of porous media. Digital rock models (DRMs) were constructed to simulate sandstone using a process-driven modeling technique which simulates sedimentation. The fractal parameters of the resulting pore geometry were calculated using the box-counting method on 2D and 3D representations of the DRMs. Our simulations indicate that increasing compaction or cementation lead to significant decreases in fractal dimension, specific surface area (S_Sp) and porosity, showing that these two diagenetic processes can affect the pore microstructure of the rock significantly. While interface fractal dimension (D_i) and S_Sp both increase slightly with decreases in sorting (grain size variety), and porosity decreases slightly. Examining the behavior of binary models, the porosity of our digital models shows a V-shaped curve as fine grain fraction increases from 0 to 1, consistent with, but higher than the theoretical values, which we attribute to incomplete packing of the grains arising from the simplified packing algorithm and finite boundary of models. The value of both S_Sp and D_i increase as the fine grain fraction increases. However, we must notice that the porosity may be underestimated, and the fractal dimension may be overestimated when we use models consisting of very fine spherical grains due to the effect of image resolution.</p>

geosciences, multidisciplinary

What problem does this paper attempt to address?

This paper attempts to study the effects of different sedimentation, compaction, cementation and the proportion of fine particles on the fractal parameters and specific surface area of porous media by combining three - dimensional process - driven digital rock modeling and fractal analysis. Specifically, the paper constructs digital rock models (DRMs) of simulated sandstone and calculates the fractal parameters of the resulting pore geometries in 2D and 3D representations using the box - counting method. The study found that increasing compaction or cementation leads to a significant decrease in fractal dimension, specific surface area (SSp) and porosity, indicating that these two diagenetic processes can significantly affect the pore microstructure of rocks. In addition, as the degree of sorting (grain size variation) decreases, the interfacial fractal dimension (Di) and SSp both increase slightly, while the porosity decreases slightly. For the binary model, when the proportion of fine particles increases from 0 to 1, the porosity of the digital model shows a V - shaped curve, which is consistent with the theoretical value but slightly higher, due to the incomplete packing of particles caused by the simplified packing algorithm and the limited boundaries of the model. At the same time, the values of SSp and Di increase as the proportion of fine particles increases. However, it should be noted that when using a very fine spherical particle model, due to the influence of image resolution, the porosity may be underestimated and the fractal dimension may be overestimated.