A NMR technique for the analysis of pore structure: Application to materials with well-defined pore structure
David P Gallegos,Kevin Munn,Douglas M Smith,Dorothy L Stermer
DOI: https://doi.org/10.1016/0021-9797(87)90251-7
IF: 9.9
1987-09-01
Journal of Colloid and Interface Science
Abstract:The application of NMR spin—lattice relaxation measurements of water contained in porous solids is investigated as a possible tool for the determination of pore size distributions. NMR methods have several potential advantages over conventional porosimetry/adsorption techniques including the study of wet porous solids, a wide range of sample sizes that may be studied, and the fact that no pore shape assumption is required. In principle, water contained in a pore will relax faster than bulk water. This decrease in the observed relaxation rate decay constant, T1, is directly related to the pore volume to surface area ratio (i.e., hydraulic radius) according to the “two-fraction, fast-exchange model.” However, the suitability of this model and NMR spin—lattice relaxation measurements for the determination of pore size distributions has not been previously demonstrated. Pore size distributions have been determined for two series of porous solids by mercury porosimetry and a NMR method. A series of four controlled-pore glasses with very narrow pore size distributions and a mean radius in the range 3.4 to 17.6 nm were studied at a frequency of 20 MHz and at four temperatures. By using four samples with similar surface chemistry/ pore shape, the validity of the two-fraction, fast-exchange model was assessed. Experiments were conducted using a 180°–τ-90° pulse sequence and the distribution of T1 was calculated using a nonnegative leastsquares routine (NNLS) presented in a previous paper. The two-fraction model described the change of mean T1 with pore radius at a given temperature. The change of the surface relaxation decay constant, T1s, fit an Arrhenius expression with an activation energy of 1.8 kcal/mole. Agreement between the mercury porosimetry and NMR derived pore size distributions is excellent. T1 measurements at both 20 and 300 MHz and 303 K were also made on a series of porous solids fabricated by pelleting submicron silica spheres. These solids exhibit afairly wide pore size distribution (⋍ one order of magnitude). The two-fraction, fast-exchange model satisfactorily described the relationship between pore size and T1. Agreement between mercury porosimetry and NMR pore size distributions is good. However, the NMR derived distributions consisted of a series of narrow peaks overlapping the single broad porosimetry peak. The surface relaxation effect, and, hence, the overall pore size sensitivity, is increased by a factor of 3 when the proton frequency is decreased from 300 to 20 MHz.
chemistry, physical