Abstract:IntroductionMRI has been increasingly used in radiation therapy to facilitate tumor and organ delineation and assess treatment response. Diffusion MRI can provide cellularity information and may enable functional‐based treatment planning and adaptation. However, strong distortion associated with the conventional diffusion‐weighted single‐shot echo‐planar imaging (DW‐ssEPI) sequence is problematic for accurate target delineation. The goal of this work is to propose a 3D diffusion sequence with minimal distortion for radiation therapy applications.MethodsA 3D diffusion‐prepared magnitude‐stabilized balanced steady‐state free precession sequence (DP‐MS‐bSSFP) was developed. A 2D navigator was acquired during the linear catalyzation stage of the bSSFP readout to estimate the phase, which was then used in a plane‐by‐plane low‐rank constrained reconstruction to correct the shot‐to‐shot k‐space inconsistency. A diffusion phantom was scanned to evaluate and compare the geometric reliability and apparent diffusion coefficient (ADC) accuracy with the conventional DW‐ssEPI. Eight landmarks were selected on each slice of the images to calculate the target registration error (TRE), which was used as a surrogate for geometric fidelity. The phantom was scanned under both 0℃ and room temperature. Brain scans were performed on five healthy volunteers. In the first volunteer, protocols of 1, 2, and 4 shots per Kz plane were compared. In vivo geometric fidelity and ADC accuracy were evaluated on the remaining four volunteers using the protocol of four shots per Kz plane. In the geometric fidelity study, 8–10 landmarks were picked on each slice to calculate the TRE. Regions of interest were placed on the white matter, the cerebellum, and the cerebrospinal fluid region to evaluate the ADC agreement between DW‐ssEPI and DP‐MS using the Bland‐Altman plot. All scans were performed at 1.5 mm isotropic resolution to meet the high‐resolution requirement of many radiotherapy applications.ResultsThe DP‐MS had drastically improved geometric accuracy compared with DW‐ssEPI on the phantom. The mean TRE decreased from 2.09 mm to 0.70 mm. The percentage difference of the ADC values between the two diffusion sequences were less than 5.5% and 7% for the 0℃ and room temperature study, respectively. The DW‐ssEPI had strong distortion and susceptibility‐related artifacts at tissue air boundary, whereas distortion was minimal in DP‐MS images. Overall, the mean/max TRE was over 2 mm/7 mm in the volunteers for DW‐ssEPI, whereas less than 0.8 mm/2 mm for DP‐MS. Good ADC agreement was observed for the white matter, the cerebellum, and the CSF based on the Bland‐Altman plots.ConclusionA 3D diffusion sequence was developed and validated. It provided high‐resolution diffusion imaging with mean distortion less than 1 mm at 1.5 T, and is a promising imaging technique for treatment planning and adaptive radiotherapy.

Regional anisotropy of airspace orientation in the lung as assessed with hyperpolarized helium-3 diffusion MRI

Probing Changes in Lung Physiology in COPD Using CT, Perfusion MRI, and Hyperpolarized Xenon-129 MRI

Assessment of lung development using hyperpolarized helium-3 diffusion MR imaging

Simultaneous measurement of pulmonary partial pressure of oxygen and apparent diffusion coefficient by hyperpolarized 3He MRI.

Undersampled Diffusion-Weighted 129Xe MRI Morphometry of Airspace Enlargement: Feasibility in Chronic Obstructive Pulmonary Disease

3D Isotropic Resolution Diffusion-Prepared Magnitude-Stabilized Bssfp Imaging with High Geometric Fidelity at 1.5 Tesla

Improved Diffusion-Weighted Hyperpolarized 129Xe Lung MRI with Patch-Based Higher-Order, Singular Value Decomposition Denoising

[The helium-3 MRT of pulmonary ventilation: the initial clinical applications]

Sci-Fri AM: Imaging - 01: Measurement of Ultra-Short and Long-Range <sup>3</sup> He Apparent Diffusion Coefficients in an Elastase-Induced Rat Model of Emphysema

Ventilation imaging of the lung: comparison of hyperpolarized helium-3 MR imaging with Xe-133 scintigraphy

Quantification of regional intrapulmonary oxygen partial pressure evolution during apnea by (3)He MRI

Posture-Dependent Human 3He Lung Imaging in an Open Access MRI System: Initial Results

Mapping of (3) He apparent diffusion coefficient anisotropy at sub-millisecond diffusion times in an elastase-instilled rat model of emphysema.

Analytic determination of lung microgeometry with gas diffusion magnetic resonance

Quantifying Spatial Distribution of Ventilation Defects in Multiple Pulmonary Diseases With Hyperpolarized 129Xenon MRI

MRI of the lung using hyperpolarized He-3 at very low magnetic field (3 mT)

Free-breathing 3D phase-resolved functional lung MRI vs breath-hold hyperpolarized 129Xe ventilation MRI in patients with chronic obstructive pulmonary disease and healthy volunteers

Emphysema Index Based on Hyperpolarized 3He or 129Xe Diffusion MRI: Performance and Comparison with Quantitative CT and Pulmonary Function Tests

Three-dimensional Isotropic Functional Imaging of Cystic Fibrosis Using Oxygen-enhanced MRI: Comparison with Hyperpolarized 3He MRI

Simultaneous magnetic resonance imaging of ventilation distribution and gas uptake in the human lung using hyperpolarized xenon-129

Measurements of regional alveolar oxygen pressure using hyperpolarized 3He MRI