Abstract:Four different thin film nanocomposite (TFN) membranes were prepared by adding different concentrations of porous Zr-MOFs (UiO-66 and UiO-66-NH2) to piperazine (PIP) aqueous solution (aqueous phase) or 1,3,5-Benzenetricarbonyl trichloride (TMC)-n-hexane solution (organic phase) by interfacial polymerization. The main purpose is to study the specific effects of different addition methods and addition amounts of nanoparticles on the structure and performance of the TFN membranes by interfacial polymerization. All four TFN membranes exhibited higher water permeability while maintaining high salt rejection compared to thin film composite (TFC) membrane. On the one hand, the TFN membranes behaves differently which are prepared by adding the same kind of nanoparticles to the aqueous phase or organic phase, respectively. The TFN membrane prepared by adding 0.2 w/v% UiO-66 to the organic phase had high water flux of 87.86 L·m-2·h-1, comparing 46.31 L·m-2·h-1 of membrane prepared by adding 0.3 w/v% UiO-66 in the aqueous phase. This is due to the fact that UiO-66 greatly slows the interfacial polymerization rate when UiO-66 is added to the organic phase, resulting in a thinner and more aperture polyamide thin film layer, reducing the water transmission resistance during filtration. Therefore, it is more economical by adding nanoparticles to organic phase than aqueous phase under the same filtering effect. On the other hand, different nanoparticles can also cause differences in performance and structure of the TFN membranes even in the same preparation manner. TFN membrane with UiO-66-NH2 in the aqueous phase has higher water permeance than the one with UiO-66 in the aqueous phase, owning to good hydrophilicity of amino group, which improves the water dispersibility of UiO-66-NH2, so that the TFN membrane is more uniform. In addition, UiO-66-NH2 slows down the process of interface polymerization, making the membrane more porous. The monomers in aqueous phase and the organic phase can be adsorbed in the pores of Zr-MOFs, which makes the interfacial polymerization occur both in the pores and on the surface of the pores. Thus, the compatibility between the polyamide and MOFs was enhanced and less defects was formed in the thin film layer, resulting in high salt rejection even the concentration of Zr-MOFs increased. This is the first time to explain that polyamide membrane has not obvious salt rejection attenuation with increasing porous material content using pore adsorption reaction monomer principle. Also, the Zr-MOFs based TFN membrane exhibited good heat resistance and anti-fouling property. This work shows that porous Zr-MOFs nanomaterials have significant advantages in the development of nanofiltration membranes with high water flux and rejection.

Ceramic hollow fiber NF membrane incorporating UiO-66 for the chlorinated hydrocarbons removal

Clay Nanosheets As Charged Filler Materials for High-Performance and Fouling-Resistant Thin Film Nanocomposite Membranes

Fabrication of Catalytic Ceramic Nanofiber Membrane with High Permeability and Superior Catalytic Performance

Investigation on the enhancement of solvent‐resistant nanofiltration membrane performance utilizing PDA‐UiO‐66@CNT as an interlayer

Polyamide Nanofiltration Membranes Incorporated with Cellulose Nanocrystals for Enhanced Water Flux and Chlorine Resistance

Preparation of Nanocavity-Contained Thin Film Composite Nanofiltration Membranes with Enhanced Permeability and Divalent to Monovalent Ion Selectivity

A thin film nanocomposite membrane with pre-immobilized UiO-66-NH2 toward enhanced nanofiltration performance

Custom-tailoring metal-organic framework in thin-film nanocomposite nanofiltration membrane with enhanced internal polarity and amplified surface crosslinking for elevated separation property

Enhanced water treatment performance of ceramic-based forward osmosis membranes via MOF interlayer

Preparation of high permeance thin-film composite nanofiltration membrane on macroporous ceramic support

Organic Nanobowls Modified Thin Film Composite Membrane for Enhanced Purification Performance toward Different Water Resources

Hybridly charged NF membranes with MOF incorporated for removing low-concentration surfactants

Novel Nanofiltration Membrane with Ultrathin Zirconia Film As Selective Layer

Porous Zr-based metal organic frameworks (Zr-MOFs) incorporated thin film nanocomposite membrane toward enhanced desalination performance.

Nanofiltration membranes with enhanced performance by constructing an interlayer integrated with dextran nanoparticles and polyethyleneimine coating

Pre-oxidation coupled with charged covalent organic framework membranes for highly efficient removal of organic chloramines precursors in algae-containing water treatment

Polyethyleneimine functionalized chitosan nanofiltration membrane for nuclear wastewater decontamination

High-flux robust ceramic membranes functionally decorated with nano-catalyst for emerging micro-pollutant removal from water

Breaking the Trade-off between Selectivity and Permeability of nanocomposite membrane modified by UIO66@PDA through nonsolvent thermally induced phase separation method

Triethanolamine-modulated interfacial polymerization toward microcrumpled nanofiltration membranes: Performances and mechanisms

Polyamide/UiO-66-NH 2 nanocomposite membranes by polyphenol interfacial engineering for molybdenum(VI) removal