Abstract:<p>Utilization of ground glass waste as supplementary cementitious material can be environmentally and sometimes economically advantageous as it converts large amounts of waste materials into value-added products and reduces the need for transportation by providing a local material resource. The research reported here aimed at developing a sustainable cementitious paste by using ground glass waste to replace Portland cement. For this, the glass waste was ground in a ball mill in different grinding times, 6 h, 24 h, and 48 h. The ground glass waste was then used to replace different proportions, 10 and 20 wt% of the cement, in pastes with water to binder ratio of 0.33. The effect of ground-glass residues on the fresh and hardened state properties were investigated In the fresh state, in general, the glass incorporation resulted in enhancement of entrapped air (from 0.8% in REF to 2.4% in 24 h–10% series) and lower cement consumption (from 1527 in REF to 1232 kg/m3 in 48 h–20%). In hydration kinetics, the glass waste improved the cement efficiency in terms that the waste added-series presented higher heat of hydration (from 4.49 in REF to 5.77 mW/g of cement in 48 h–20%). Also, for later ages, was possible to note by thermogravimetry that the waste added-series presented lower portlandite (Ca(OH)2) amount in comparison with reference (in 90 days from 3.14 to 2.11% in 48 h–20%), indicating the pozzolanic reaction of the glass waste. In a hardened state, the cement replacement by glass waste did not improve the mechanical strength. However, the binder index (associated with cement efficiency) was considerably lower than the reference (on average the binder index of the glass waste added-samples were 6.5, 10.6, and 8.5% at 7, 28, and 90 days, respectively, lower), indicating a higher efficiency cement replacement.</p>

Comparison of ground waste glass with other supplementary cementitious materials

Reusing Waste Glass Powder to Improve the Strength Stability of Cement at HTHP

A review of ground waste glass as a supplementary cementitious material: A focus on alkali-silica reaction

Effect of partial replacement of the cement by glass waste on cementitious pastes

Studying the Effects of Varied Dosages and Grinding Times on the Mechanical Properties of Mortar

Characterization and Performance of High Volume Recycled Waste Glass and Ground Granulated Blast Furnace Slag or Fly Ash Blended Mortars

Effect on Compression Strength of Masonary Mortar by Replacing Fine Aggregates with Waste Glass

Mechanical and Material Properties of Mortar Reinforced with Glass Fiber: An Experimental Study

Experimental Study on Long-Term Mechanical Properties and Durability of Waste Glass Added to OPC Concrete

Performance of concrete with the incorporation of waste from the process of stoning and polishing of glass as partial replacement of cement

Effective Utilization of Waste Glass as Cementitious Powder and Construction Sand in Mortar

Performance Evaluation of Sustainable High Strength Mortars Incorporating High Volume Waste Glass As Binder

Recycling Local Waste Glass Bottles into Cement Paste: Effect on Hydration, Microstructure, and CO2 Emission

An Eco-Sustainable Production of Cement Mortar Containing Waste Glass as Partial Replacement of Cement

An investigation on the physical properties of cementitious pastes modified with low dosage of waste glass powder and silica fume

Assessing the modification efficiency of waste glass powder in hydraulic construction materials

Preparation of waste glass powder by different grinding methods and its utilization in cement-based materials

Durability of self-compacting concrete containing waste bottle glass and granulated slag

Valorization of glass powder waste, crushed and dune sands in the mix design of ultra-high performance fiber reinforced concrete: Assessing effect of waste variability

Effect of glass powder and silica fume on mechanical properties and on alkali-silica reaction of recycled glass mortars

Waste Glass As Binder in Alkali Activated Slag–fly Ash Mortars