Abstract:Lithium-sulfur (Li-S) battery has attracted wide research attention due to its high energy density, high earth-abundance and low-cost. However, the dissolution of lithium polysulfides (LiPSs) and corresponding shuttle will lead to serious capacity degradation and worse cycling stability of Li-S batteries. To address such issues, herein, we firstly present a novel interlayer of WN0.67-embedded N-doped graphene-nanosheets (WN0.67@NG) via a facile solvothermal reaction followed by nitriding treatment. The Li-S cell equipped with WN0.67@NG modified polypropylene (PP) separator exhibits outstanding electrochemical performances: a long-term stability with only a capacity decay of 0.07% per cycle over 200 cycles and a large capacity of 725 mAh g−1 at 4C; interestingly, a favorable capacity of 776 mAh g−1 can be maintained after 100 cycles at 0.2C for assembled Li-S pouch cell under a high sulfur loading conditions of 4.3 mg cm−2 with lean electrolyte occupation (6 μL mg−1). The outstanding performance can be attributed to the following advantages of WN0.67@NG interlayer: the high conductivity of NG sheets can facilitate the electron transfer and act as a physical block for restricting the LiPSs shuttle; most importantly, the polar WN0.67 nanoneedles embedded on the NG sheets not only provide abundant active sites for chemisorption and catalytic conversion of LiPSs, but also contribute to the nucleation and growth of Li2S; further theoretical calculations and in-situ Raman spectra clearly reveal the adsorption and catalytic conversion mechanism of WN0.67@NG interlayer at the molecular level. The work provides new insight into rational design and facile fabrication of multifunctional separators for industrial applications in high-performance Li-S batteries.

Free-standing nitrogen-doped graphene paper as electrodes for high-performance lithium/dissolved polysulfide batteries

Selective Adsorption and Electrocatalysis of Polysulfides Through Hexatomic Nickel Clusters Embedded in N-Doped Graphene Toward High-Performance Li-S Batteries

Powder metallurgy template growth of 3D N-doped graphene foam as binder-free cathode for high-performance lithium/sulfur battery

Porphyrin‐Derived Graphene‐Based Nanosheets Enabling Strong Polysulfide Chemisorption and Rapid Kinetics in Lithium–Sulfur Batteries

Mesoporous N-doped graphene prepared by a soft-template method with high performance in Li-S batteries.

WN0.67-Embedded N-doped Graphene-Nanosheet Interlayer as efficient polysulfide catalyst and absorbant for High-Performance Lithium-Sulfur batteries

Single Nickel Atoms on Nitrogen‐Doped Graphene Enabling Enhanced Kinetics of Lithium–Sulfur Batteries

Self-assembled N-graphene nanohollows enabling ultrahigh energy density cathode for Li-S batteries

Facilitation polysulfides adsorption/catalysis by nitrogen/phosphorous co-doped carbon nanofibers networks for advanced lithium/polysulfides batteries

3D graphene framework supported Li2S coated with ultra-thin Al2O3 films: binder-free cathodes for high-performance lithium sulfur batteries

High-rate, Ultralong Cycle-Life Lithium/sulfur Batteries Enabled by Nitrogen-Doped Graphene.

Polarity-induced precipitation of S/Li2S confined into N and S co-doped porous graphene layered matrix for lithium sulfur batteries

Uniform Polypyrrole Layer-Coated Sulfur/Graphene Aerogel Via the Vapor-Phase Deposition Technique As the Cathode Material for Li-S Batteries

Efficient Polysulfide Blocker from Conductive Niobium Nitride@graphene for Li-S Batteries

TiN nanocrystal anchored on N-doped graphene as effective sulfur hosts for high-performance lithium-sulfur batteries

MoP QDs@graphene As Highly Efficient Electrocatalyst for Polysulfide Conversion in Li-S Batteries

Reduced porous carbon/N-doped graphene nanocomposites for accelerated conversion and effective immobilization of lithium polysulfides in lithium-sulfur batteries

A Porous Nitrogen and Phosphorous Dual Doped Graphene Blocking Layer for High Performance Li–S Batteries

Strong Lithium Polysulfide Chemisorption on Electroactive Sites of Nitrogen-Doped Carbon Enables High-Performance Lithium-Sulfur Battery Cathodes

Ultrafine NbN Nanoparticle Decorated Nitrogen-Doped Carbon Nanosheets with Efficient Polysulfide Catalytic Conversion for Superior Li-S Batteries

Nitrogen‐Doped Graphene‐Supported Mixed Transition‐Metal Oxide Porous Particles to Confine Polysulfides for Lithium–Sulfur Batteries