Abstract:While the interfacial phases between Al and high-entropy alloy (HEA) share the same types as that between Al and steel, it has been found previously that the thermal stability of the Al-HEA interfacial phases is significantly higher than that of the Al-steel interfacial phases. To further elucidate the reason for the exceptional thermal stability of Al-HEA interfacial phases, this study investigated the evolution of the interfacial phases formed between Al alloy and FeCoCrNiMn HEA during annealing. An Al-FeCoCrNiMn thin film diffusion couple was extracted from a friction stir lap welding (FSLW) joint by focused ion beam and then annealed at 400 degrees C. An amorphous layer is formed initially at the interface due to the high strain rate deformation during FSLW. The amorphous layer remained even after prolonged annealing at 400 degrees C (similar to 0.72 T-m of Al alloy) for 60 min with very limited thickening (from 50 nm to 55 nm), showing remarkable thermal stability at the relatively high temperature. Al13Fe4-type intermetallic compound (IMC) with the Fe site occupied by Fe, Co, Cr, Ni and Mn first nucleates at the interface between Al alloy and amorphous layer. With the annealing time extended to 180 min, the amorphous layer is partially transformed into Al5Fe2-type IMC. The rate constant for the thickening of the reaction layer at the Al/FeCoCrNiMn interface is 0.03 mu m center dot min(1/2), which is much smaller than (only 0.02 times) that at the Al/steel interface under similar annealing condition. The high thermal stability of Al-HEA interfacial layer is thus attributed to the slow kinetics in crystallization of the initially formed amorphous layer, the barrier effect of amorphous layer for interdiffusion, and the reduced diffusivity inside of IMCs caused by significant fluctuations in lattice potential energy due to high-density doping with HEA elements. This finding provides new insights into the fabrication of thermally stable Al-HEA hybrid structures suitable for service conditions involving high-temperature exposure.

High-entropy alloy: An alternative approach for high temperature microwave-infrared compatible stealth

High temperature infrared-radar compatible stealthy metamaterial based on an ultrathin high-entropy alloy

New lightweight high-entropy alloy coatings: Design concept, experimental characterization, and high-temperature oxidation behaviors

The microstructural evolution of dual phase high entropy alloy thin films by annealing

A Strong-Yet-ductile High-Entropy Alloy in a Broad Temperature Range from Cryogenic to Elevated Temperatures

Transitional and refractory elements-based high entropy alloy developed through mechanical alloying and microwave sintering: Tribological and corrosion responses

Exploring the Compositional Space of High-Entropy Alloys for Cost-Effective High-Temperature Applications

Development of Oxidation Resistant Refractory High Entropy Alloys for High Temperature Applications: Recent Results and Development Strategy

Microstructure Design of High-Entropy Alloys Through a Multistage Mechanical Alloying Strategy for Temperature-Stable Megahertz Electromagnetic Absorption

Lightweight, Ultrastrong and High Thermal-Stable Eutectic High-Entropy Alloys for Elevated-Temperature Applications

Synthesis and Mechanical Characterization of a CuMoTaWV High-Entropy Film by Magnetron Sputtering

Design and Development of High-Entropy Alloys with a Tailored Composition and Phase Structure Based on Thermodynamic Parameters and Film Thickness Using a Novel Combinatorial Target

Introducing a new heterogeneous nanocomposite thin film with superior mechanical properties and thermal stability

Nanocrystalline High-Entropy Alloys: A New Paradigm in High-Temperature Strength and Stability

Microstructure evolution and properties of Fe-Ni-Cr-Co-Mo-W high-entropy alloy coatings by plasma surface alloying technology

Precipitation-hardened High-Entropy Alloys for High-Temperature Applications: A Critical Review

Microstructure, Phase Stability and Mechanical Properties of Nb–Ni–Ti–Co–Zr and Nb–Ni–Ti–Co–Zr–Hf High Entropy Alloys

Radar‐infrared compatible camouflage performance of high‐entropy alloy coating enhanced by double‐layer hexagonal meta‐surface

Electromagnetic Wave Absorption Performance of FeCoNiMn0.5Al0.2 High Entropy Alloys Governed by Nanocrystal Evolution

Magnetron co-sputtering synthesis and nanoindentation studies of nanocrystalline (TiZrHf)x(NbTa)1−x high-entropy alloy thin films

Evolution of Interfacial Phases Between Al Alloy and High Entropy Alloy During Annealing