Thienopyrimidine‐derived multifunctional fluorescence sensor for the detection of Cu2+, Fe3+, and PPi in different solvents

Manman Shi,Mingyi Kang,Peng Liu,Han Zhou,Meishan Pei,Guangyou Zhang,Xiaofeng Yang

DOI: https://doi.org/10.1002/bio.4744

IF: 2.613

2024-05-01

Luminescence

Abstract:When treated with Cu2+ in DMSO/H2O buffer, R1 showed a phenomenon of fluorescence quenching, which was reversible with the action of EDTA. When treated with Fe3+ in DMF/H2O buffer, R1 exhibited the same phenomenon, but fluorescence was recovered with PPi quantitatively. Test strips of R1 were fabricated successfully for on‐site detection of Cu2+ and Fe3+. Hydrazine substituted thienopyrimidine, a new fluorophore, was used to synthesize a novel Schiff base R1 as a chemosensor via the condensation with p‐formyltriphenylamine, and the structure was confirmed using nuclear magnetic resonance spectroscopy (NMR) and mass spectrometry (MS) analysis. When treated with Cu2+ in dimethylsulfoxide (DMSO)/H2O buffer, R1 showed a phenomenon of fluorescence quenching, which was reversible with the action of ethylenediaminetetraacetic acid (EDTA). When treated with Fe3+ in dimethylformamide (DMF)/H2O buffer, R1 exhibited the same phenomenon, but fluorescence was recovered with inorganic pyrophosphate (PPi) quantitatively. The complexation ratios for R1‐Cu2+ and R1‐Fe3+ were both 1:2, which were manifested by MS titrations and corresponding Job's plots. The limits of detection of R1 for Cu2+ and Fe3+ were 3.11 × 10−8 and 1.24 × 10−7 M, respectively. The sensing mechanism of R1 toward Cu2+ and Fe3+ was confirmed using density functional theory calculations and electrostatic potential analysis. Test strips of R1 were fabricated successfully for on‐site detection of Cu2+ and Fe3+. In addition, R1 was applied to recognize Cu2+ and Fe3+ in actual water samples with satisfactory recovery.

chemistry, analytical