Abstract:Carbonized polymer dots (CPDs) have attracted widespread attention owing to their unique properties and are usually prepared from monomers of polymers or polymers. To reduce the waste of high-value petropolymers and environmental pollution, a simple and green method for the preparation of CPDs using a hydrothermal technique based on the cross-linking enhanced emission effect was proposed, in which nylon 66 waste fibers were used as a precursor and glutaraldehyde as a cross-linking agent. The as-prepared CPDs possessed polymer/carbon hybrid structures with a 3.5 nm average diameter, and hydroxyl (-OH), carboxyl (-COOH), and amino (-NH2) groups were present on the surface of CPDs. It can be found that the as-prepared CPDs display excitation-dependent photoluminescence emission, which is mainly attributed to the molecular state luminescence center. Because the molecular state fluorescence of CPDs could be affected by the presence of Fe3+ and the change of pH values, the as-prepared CPDs can be used as a probe for the detection of the concentration of Fe3+ and the pH variations of solution. The fluorescence intensity of CPDs was selectively quenched by Fe3+ in the range from 1 to 145 μM. In virtue of the static quenching of CPDs by Fe3+, a sensing system was fabricated for the quantitative detection of Fe3+, and its limit of detection was 0.1 μM. Based on the electrostatic doping/charging of CPDs, a pH sensor was fabricated. It showed that the fluorescence intensity of CPDs decreased along with the increase of pH from 2.60 to 12.6. What is more, the CPDs were found to be an alternative to traditional fluorescent inks for encryption and information storage.

Bright green emission non-conjugated polymer dots: pH trigged hydrogel for specific adsorption of anionic dyes and visual detection of tert-butylhydroquinone

Water-soluble non-conjugated polymer dots with strong green fluorescence for sensitive detection of organophosphate pesticides

'Imperfect' conjugated polymer nanoparticles from MEH-PPV for bioimaging and Fe(III) sensing.

Highly Selective and Sensitive Detection of Pb2+ in Aqueous Solution Using Tetra(4-pyridyl)porphyrin-Functionalized Thermosensitive Ionic Microgels

Polymer Dots for Photoelectrochemical Bioanalysis

Hyperbranched copolymer containing triphenylamine and divinyl bipyridyl units for fluorescent chemosensors

Effect of Ph on the Detection of Explosive in Aqueous Solution Using A Hyperbranched Polytriazole with Aggregation-Induced Emission Characteristics

Polymer Dots of Peryleneimide-Functionalized Polyethyleneimine: Facile Synthesis and Effective Fluorescent Sensing of Iron (iii) Ions

A Multifunctional Piperazine-Modified Tetraphenylethene Derivative: Hazardous Chemical Detection and Lysosome-Targeted Cell Imaging

Non-conjugated polymer dots for fluorometric and colorimetric dual-mode detection of quercetin

One-pot synthesis of fluorescent non-conjugated polymer dots for Fe3+ detection and temperature sensing

Room temperature preparation of water-soluble polydopamine-polyethyleneimine copolymer dots for selective detection of copper ions

Highly Efficient Electrochemiluminescence of Cyanovinylene-Contained Polymer Dots in Aqueous Medium and Its Application in Imaging Analysis

Simple and Green Synthesis of Carbonized Polymer dots from Nylon 66 Waste Fibers and its Potential Application

Electrochemiluminescent Resonance Energy Transfer of Polymer Dots for Aptasensing

Fluorescent non-conjugated polymer dots for targeted cell imaging

Intrinsic bright green emission from hyperbranched polyphosphate esters: preparation, film fabrication and Fe3+ sensing

Highly Sensitive Polydiacetylene Ensembles for Biosensing and Bioimaging

Green fluorescent carbon dots for sensing of quercetin and pH and cell imaging

One-Pot Hydrothermal Synthesis of High Quantum Yield Orange-Emitting Carbon Quantum Dots for Sensitive Detection of Perfluorinated Compounds

Phase transferred and non-coated, water soluble perovskite quantum dots for biocompatibility and sensing.