Abstract:Although the formation of nanosized and defective δ-MgCl2 is essential for the performance of Ziegler–Natta catalysts, the process has not sufficiently been elucidated due to certain limitations in characterization. Here, the formation of nanostructures and active surfaces of Ziegler–Natta catalysts was investigated in detail based on a multifaceted set of characterization techniques represented by X-ray total scattering and various spectroscopies in correlation with chemical composition analysis and polymerization tests. Solid samples were extracted in the course of catalyst preparation from Mg(OEt)2 and subjected to the analysis. Several interesting results were found. The addition of TiCl4 almost spontaneously converts Mg(OEt)2 into MgCl2 seeds mainly exposing the {001} basal surface, whose dimensions are below 2 nm; a large Ti amount remains on the material as physisorbed 4-fold-coordinated TiCl x (OEt)4–x species. The heating treatment removes the physisorbed TiCl x (OEt)4–x and/or convert them into chemisorbed 6-fold-coordinated TiCl x (OEt)4–x , while the subsequent addition of an internal donor (here dibutyl phthalate, DBP) promotes a substantial reconstruction and growth of MgCl2 seeds to almost the same size as the final catalyst (ca. 6 nm), with the exposure of the more catalytically relevant lateral surfaces. DBP is in one part adsorbed on MgCl2 surfaces and in the other part complexed with Ti sites. This complex is only partially removed in the following steps of the synthesis. The second TiCl4 addition replaces the chemisorbed TiCl x (OEt)4–x with 6-fold-coordinated TiCl4 species, but it also causes side reactions with DBP, as testified by the formation of phthaloyl chloride. After activation by triethylaluminum (TEAl), the activity per Ti for ethylene was almost constant throughout the whole preparation process after the initial TiCl4 addition, whereas the activity for propylene was negligible before the addition of the donor and increased dramatically in the subsequent steps of the preparation. This was further investigated based on spectroscopies for TEAl-activated samples in order to individuate the active Ti species responsible for the catalysis and to monitor the fate of DBP upon TEAl reaction. The multifaceted characterization approach allowed us to integrate information on the formation of δ-MgCl2, their surfaces, and adsorbed species, providing us with deep insights into the meaning of each step within an industrial catalyst preparation method that has been empirically refined over a long history.

Probing the coordinative unsaturation and local environment of Ti³⁺ sites in an activated high-yield Ziegler-Natta catalyst.

Highly Active Ethylene Polymerization And Regioselective 1-Hexene Oligomerization Using Zirconium And Titanium Catalysts With Tridentate [Ono] Ligands

Superactive and stereospecific catalysts. III. Definitive identification of active sites by electron paramagnetic resonance

Electronic Properties of Ti Sites in Ziegler–Natta Catalysts

Effect of Internal Electron Donor on the Active Center Distribution in MgCl2-supported Ziegler–Natta Catalyst

Well-Defined Ti Surface Sites in Ziegler-Natta Pre-Catalysts from 47/49Ti Solid-State Nuclear Magnetic Resonance Spectroscopy

New Insights into the Nature of Ti(II) and Ti(III) Active Sites in the Heterogeneous Ziegler–Natta Catalyst

Well-Defined Ti Surface Sites in Ziegler-Natta Pre-Catalysts from 47/49 Ti Solid-State Nuclear Magnetic Resonance Spectroscopy

Unexpected Reactions between Ziegler–Natta Catalyst Components and Structural Characterization of Resulting Intermediates

Magnesium chloride supported catalysts for olefin polymerization. XIX. Titanium oxidation states, catalyst deactivation, and active site structure

Formation of Highly Active Ziegler–Natta Catalysts Clarified by a Multifaceted Characterization Approach

Synchronous TiCl 4 Immobilization and Tetrahydrofuran Migration in Modified Ziegler-Natta Catalysts

Highly active Ziegler-Natta catalyst for propylene polymerization I. The effect of internal electron donor

Highly active Ziegler-Natta catalyst for propylene polymerization. (1) The effect of internal electron donor

Highly active Ziegler-Natta Catalysts for propylene polymerization (2) effects of Al/Ti ratio and polymerization temperature

Cobalt Single Atoms on Tetrapyridomacrocyclic Support for Efficient Peroxymonosulfate Activation.

Density Functional Calculations on the Distribution, Acidity, and Catalysis of Ti-Iv and Ti-Iii Ions in Mcm-22 Zeolite

Tracking Coordination Environment and Reaction Intermediates in Homo- and Heterogeneous Epoxidation Catalysts via Ti L2,3-edge NEXAFS

Nature of Reactive Sites in TS-1 from 15N solid-state NMR and Ti K-edge X-Ray Absorption Spectroscopic Signatures upon Pyridine Adsorption

Characterization of a model Ziegler–Natta catalyst for ethylene polymerization

Fvsynchronous TiCl4 Immobilization and Tetrahydrofuran Migration in Modified Ziegler-Natta Catalysts