Design of a Five-Fingered Hand with Full-Fingered Tactile Sensors Using Conductive Filaments and Its Application to Bending after Insertion Motion

Kazuhiro Miyama,Shun Hasegawa,Kento Kawaharazuka,Naoya Yamaguchi,Kei Okada,Masayuki Inaba

DOI: https://doi.org/10.1109/Humanoids53995.2022.10000181

2024-12-01

Abstract:The purpose of this study is to construct a contact point estimation system for the both side of a finger, and to realize a motion of bending the finger after inserting the finger into a tool (hereinafter referred to as the bending after insertion motion). In order to know the contact points of the full finger including the joints, we propose to fabricate a nerve inclusion flexible epidermis by combining a flexible epidermis and a nerve line made of conductive filaments, and estimate the contact position from the change of resistance of the nerve line. A nerve inclusion flexible epidermis attached to a thin fingered robotic hand was combined with a twin-armed robot and tool use experiments were conducted. The contact information can be used for tool use, confirming the effectiveness of the proposed method.

Robotics

What problem does this paper attempt to address?

The problem that this paper attempts to solve is to develop a robotic hand system capable of tool operation, especially for the motion of bending fingers after insertion (bending after insertion motion). Specifically, the research aims to solve the following two key problems:

1. **Full - finger tactile perception**:
- After the tool is inserted, any part of the finger (including the dorsal and palmar sides) may come into contact with the tool or the environment. In order to obtain the information of the current contact point and perform control, a tactile sensor covering the entire finger (including joints) is required.

2. **Imitating the human hand structure**:
- In order to achieve complex tool operations, the robot's fingers need to have flexibility and thinness similar to those of human fingers. By imitating the mechanism of the human bone structure, control closer to human actions can be achieved.

To solve these problems, the author proposes a "nerve inclusion flexible epidermis" that combines a flexible epidermis and conductive wires, and verifies its effectiveness in tool operation through experiments. This method can not only detect the contact points of all parts of the finger, but also ensure that the finger does not self - contact when bent, thus achieving more natural and flexible tool operation.

### Formula summary

The main formula involved in the paper is used to estimate the position of the contact point, and the formula is as follows:

\[ p = \begin{cases}
100 - \frac{V_{\text{max}} - v}{V_{\text{max}} - V_{\text{mid}}} \times 20 & \text{if } V_{\text{mid}} < v < V_{\text{max}} \\
\frac{v - V_{\text{min}}}{V_{\text{mid}} - V_{\text{min}}} \times 80 & \text{if } V_{\text{min}} < v < V_{\text{mid}}
\end{cases} \]

where:
- \( p \) is the contact point ratio, representing the percentage of the contact position in the effective total length.
- \( v \) is the sensor data.
- \( V_{\text{max}} \) is the steady - state sensor data.
- \( V_{\text{mid}} \) is the sensor data when the tip of the nerve wire is conducting.
- \( V_{\text{min}} \) is the minimum value of the sensor data.

These parameters are obtained through calibration to ensure the accuracy of the measurement.