Abstract:Channel parameter estimation is crucial for optimal designs of next-generation reconfigurable intelligent surface (RIS)-empowered communications and sensing. Tensor-based mechanisms are particularly effective, capturing the multi-dimensional nature of wireless channels, especially in scenarios where RIS integrates with multiple-antenna devices. However, existing studies assume either a line-of-sight (LOS) scenario or a blocked condition for non-RIS channel. This paper solves a novel problem: tensor-based channel parameter recovery for active RIS-aided multiple-antenna wideband connections in a multipath environment with non-RIS paths. System settings are customized to construct the received signals as a fifth-order canonical polyadic (CP) tensor. Four of the five-factor matrices unfortunately contain redundant columns, and the remaining one is a Vandermonde matrix, which fails to satisfy the Kruskal condition for tensor decomposition uniqueness. To address this issue, spatial smoothing and Vandermonde structured CP decomposition (VSCPD) are applied, making the tensor factorization problem solvable and providing a relaxed general uniqueness condition. A sequential triple-stage channel estimation framework is proposed based on the factor estimates. The first stage enables multipath identification and algebraic coarse estimation, while the following two stages offer optional successive refinements at the cost of increased complexity. The closed-form Cramer-Rao lower bound (CRLB) is derived to assess the estimation performance. Herein, the noise covariance matrix depends on multipath parameters in our active-RIS scenario. Finally, numerical results are provided to verify the effectiveness of proposed algorithms under various evaluation metrics.
What problem does this paper attempt to address?
The problem that this paper attempts to solve is: in a multi - antenna broadband system assisted by Active Reconfigurable Intelligent Surface (Active RIS) with non - RIS paths in a multipath environment, the problem of channel parameter recovery based on tensor decomposition. Specifically, the paper aims to estimate channel parameters through tensor methods, especially in cases including Line - of - Sight (LOS) and multipath scattering, in order to achieve accurate estimation of Channel State Information (CSI).
### Problem Background
Traditional RIS research usually assumes that the direct channel between User Equipment (UE) and Base Station (BS) is blocked, so it relies on RIS to create an additional cascaded link (UE - RIS - BS). However, in practical applications, the direct UE - BS channel may exist, which makes channel estimation more complicated. In addition, most of the existing research focuses on passive RIS or hybrid RIS, while Active RIS can amplify signals and adjust phases, thus providing better performance.
### Main Challenges
1. **Multipath Environment**: In a multipath environment, channel parameter estimation becomes more complicated because multiple propagation paths need to be considered.
2. **Existence of Non - RIS Paths**: Besides RIS - assisted paths, there are also non - RIS paths, which pose higher requirements for channel estimation.
3. **Uniqueness Problem of Tensor Decomposition**: Due to the existence of redundant columns in the tensor factor matrix, the classical Kruskal condition cannot be satisfied, which further affects the uniqueness and accuracy of tensor decomposition.
### Solutions
To solve the above problems, the paper proposes a method based on structured tensor decomposition, which specifically includes the following aspects:
1. **Tensor Construction**: Represent the received signal as a fifth - order tensor, and use spatial smoothing and Vandermonde - structured CP decomposition (VSCPD) to deal with the uniqueness problem in tensor decomposition.
2. **Three - stage Channel Estimation Framework**:
- First stage: Conduct multipath identification and algebraic rough estimation.
- The following two stages: Provide optional continuous refinement to improve the estimation accuracy at the cost of increased computational complexity.
3. **Cramér - Rao Lower Bound (CRLB) Analysis**: Derive the closed - form CRLB to evaluate the estimation performance, and consider the impact of thermal noise introduced by Active RIS on the total received noise covariance matrix.
### Summary
This paper overcomes the limitations in traditional RIS research by introducing Active RIS and the tensor decomposition method in a multipath environment, especially providing a more accurate channel parameter estimation method in multipath scenarios. This method not only improves the accuracy of channel estimation but also provides new ideas for the design of future wireless communication systems.